Different excavation methods lead to substantial changes in the relaxation zone of the surrounding rock. The stress characteristics of the support structure become more complex during the process of excavation method conversion. It is essential to design a well-considered construction plan to minimize the disruptions caused by excavation method conversion. This work takes a tunnel in Jiangsu Province, China, as the engineering background and establishes a numerical model for the conversion from the double-side-drift method to the three-bench method. Based on a numerical investigation, this study analyzed the deformation of surrounding rock and the stress state of the support structure during the excavation method conversion. The results showed that excavation method conversion can accelerate the deformation rate of the surrounding rock, causing the support structure to bear greater pressure. This leads to a significant increase in the circumferential stress at the junction of two excavation methods. Setting up a reinforced area during the process of excavation method conversion can improve the stress state of the support structure. Finally, an analysis of the parameters of the reinforced area was conducted, and a reasonable construction plan was proposed. This study can provide guidance for subsequent construction projects.
To investigate the propagation of stress waves in viscoelastic joints under blasting loads, and their impact on crack propagation and dynamic response in rock masses, a numerical model incorporating intersecting viscoelastic joints was developed using LS-DYNA. This study focuses on the influence of various joint geometric parameters, including thickness and angle, on stress wave propagation and damage patterns in rock. The Riedel–Hiermaier–Thoma (RHT) model was employed to simulate the dynamic behavior of rock, while the Poynting–Thomson model was used to describe the viscoelastic properties of the joint fillings. The simulation results provide detailed insights into the principal stress, displacement, and particle vibration velocity around the joints. Based on the stress wave propagation theory, the velocity transmission coefficients were calculated to quantify the attenuation of stress waves across the joints. The findings demonstrate that viscoelastic joint properties significantly affect the damage patterns in the rock mass. Specifically, the area of the crushed zone and the width of cracks on the blasting side are proportional to joint thickness, while crack propagation at the joint tips is governed by differences in principal stress. Moreover, the propagation of vibration velocity is notably weakened at the second joint, highlighting the critical role played by joint characteristics in stress wave dynamics. These results underscore the complex interaction between joint properties and stress wave behavior in rock masses, providing valuable insights for optimizing blasting designs and improving the safety of underground engineering projects.