In this paper, we analyze the conditions making transient faults (TFs) affecting the nodes of conventional latch structures generate output soft errors (SEs). We investigate the susceptibility to TFs of all latch nodes and identify the most critical one(s). We show that, for standard latches using back-to-back inverters for their positive feedback, the internal nodes within their feedback path are the most critical. Such nodes will be hereafter referred to as internal feedback nodes. Based on this analysis, we first propose a low-cost hardened latch that, compared to alternative hardened solutions, is able to completely filter out TFs affecting its internal feedback nodes while presenting a lower susceptibility to TFs on the other internal nodes. This is achieved at the cost of a reduced robustness to TFs affecting the output node. To overcome this possible limitation (especially for systems for high-reliability applications), we propose another version of our latch that, at the cost of a small area and power consumption increase compared to our first solution, also improves the robustness of the output node, which can be higher than that of alternative hardened solutions. Additionally, both proposed latches present a comparable or higher robustness of the input node than alternative solutions and provide a lower or comparable power-delay product and area overhead than classical implementations and alternative hardened solutions.

First, a new high-performance robust latch (referred to as HiPeR latch) is presented that is insensitive to transient faults affecting its internal and output nodes by design, independently of the size of its transistors. Then, a modified version of the HiPeR latch (referred as HiPeR-CG) is proposed that is suitable to be used together with clock gating. Both proposed latches are faster than the latches most recently presented in the literature, while providing better or comparable robustness to transient faults, at comparable or lower costs in terms of area and power, respectively. Therefore, thanks to the good trade-offs in terms of performance, robustness, and cost, our proposed latches are particularly suitable to be adopted on critical paths.

Carbon nanotubes (CNTs) have been widely proposed as interconnect fabric for nano and very deep submicron (silicon-based) technologies due to their robustness to electromigration. In this paper, issues associated with crosstalk among bus lines implemented by CNTs are investigated in detail. CNT-based interconnects are modeled and the effects of crosstalk on performance and correct operation are evaluated by simulation. Existing models are modified to account for geometries in bus architectures made of parallel single-walled nanotubes and a single multiwalled nanotube. New RLC equivalent circuits are proposed for these bus architectures. A novel bus architecture with low crosstalk features is also proposed. This bus architecture is made of dual-walled nanotubes arranged in parallel. In this architecture, the crosstalk-induced delay and corresponding uncertainty (as well as crosstalk-induced peak voltage) are significantly reduced; a modest area penalty is incurred. Reductions up to 59% for the crosstalk-induced delay and up to 81% for the crosstalk-induced peak voltage are reported. These results confirm that the proposed bus arrangement noticeably improves performance and provides reliable operation

Signal integrity in high-speed bus designs is put at risk by crosstalk-related-bus delays. This article provides a comprehensive study of the usefulness of error-correcting code (ECC) redundancy in reducing such delays. It shows that dual Rail codes perform better at this task than Hamming codes. We analyze the impact of different ECCs on crosstalk-induced-bus delays (CIBD). We investigate the possibility of exploiting the information redundancy previously necessary to limit CIBD, thus reducing the consequent risk of a system's incorrect operation.

In this paper, we address the problem of modeling the thermal behavior of photovoltaic (PV) cells undergoing a hotspot condition. In case of shading, PV cells may experience a dramatic temperature increase, with consequent reduction of the provided power. Our model has been validated against experimental data, and has highlighted a counterintuitive PV cell behavior, that should be considered to improve the energy efficiency of PV arrays. Then, we propose a hotspot detection scheme, enabling to identify the PV module that is under hotspot condition. Such a scheme can be used to avoid the permanent damage of the cells under hotspot, thus their drawback on the power efficiency of the entire PV system.