This study combines the processing and interpretation of magnetic data with geological fieldwork. The purpose is to establish the geological map and rutile mineralization targets map of Minta area (Haute-Sanaga, Cameroon). To this, a strategic geological field survey was first conducted. It highlighted some geological structures, especially magnetite quartzites, which is considered as the potential sources of primary rutile mineralization. Several methods were applied to the magnetic data, including upward continuation (UC), vertical derivative (DZ), analytical signal (AS) and horizontal gradient magnitude (HGM). The regional-residual separation method based on the UC was used to develop the residual map which was very helpful to understand the distribution of magnetic anomalies related to rutile mineralization in this area. The structural model of the study area was established by combining the analysis of the AS and HGM maxima with the analysis of the topographic model. Since magnetic relief variation characterizes the lithological information changes according to the filtered map considered, a set of categorization processes based on the anomaly signals was applied to each of filtered maps according to the geological information sought. It is based on the interpretation of structural models, combined with previous works and the spatial distribution of geological data collected. This process produced a set of partial lithological models, which were then combined with the interpreted structural model to produce the geological map of the study area. This map also shows the spatial distribution of the various targets of potential rutile mineralization interpreted on the DZ model as rectilinear anomalies, with a signal range of 0.78–0.88 nT/m.
The Sanaga River Valley is a deep-seated structure of about 220 km in width, bounded on its northern and southern sides by 025-0550 fault zones. Its internal structure has been very little described before this study. It is characterized by the presence of surface features where a thick stratum of shale and argillaceous sandstones have been documented. The use of electrical resistivity tomography for near-surface imaging and hydrogeological prospecting within shale succession is widespread. However, several methods of spatial modeling of resistivity contours are generally proposed for the interpretation of inverse resistivity model sections. To determine the most appropriate method for interpreting resistivity tomographies in the context of subsoil marked by significant heterogeneity, logarithmic contour intervals, and linear contour interval processing were implemented on data collected over five areas. The data consists of outcrops data, cuttings samples from groundwater boreholes, and resistivity sections ranging in length from 240 to 1000 m. Well-control of the inverse resistivity model sections derived from both processes shows that the linear contour intervals modeling gives a more realistic picture of the reservoir size of the wa-ter-bearing sand in both shale and argillaceous sandstone succession. The sedimentary architecture over Sanaga fault breccia is marked by vertical intrusion anomalies up to 80 m high. The shape of these anomalies, as well as the very low resistivity values that characterize them, suggests that they could be related to mud intrusion.