CuCrO₂ (mcconnellite) was synthesized using both the solid-state method and microwave dielectric firing. It was characterized as a novel black ceramic pigment for use in various industrial glazes. For the first time, the application of mcconnellite (CuCrO₂) and its coloured glazes as selective solar absorbers (SSA) for integral ceramic solar collectors has been reported. The addition of quartz or anatase was investigated as colour modifiers to prevent the bluing of the pigment in Zn-containing glazes, a phenomenon associated with the exsolution of copper. Furthermore, doping with lanthanide oxides was explored to address two key challenges: controlling the formation of pinhole defects in porcelain glazes, which are linked to the destabilization of Cu⁺, and adjusting the IR cut-off wavelength to improve its performance as SSA.
CuCrO2 (mcconnellite) was synthesized using both the solid-state method and microwave dielectric firing. It was characterized as a novel black ceramic pigment for use in various industrial glazes. For the first time, the application of mcconnellite (CuCrO2) and its coloured glazes as selective solar absorbers (SSA) for integral ceramic solar collectors has been reported. The addition of quartz or anatase as colour modifiers was investigated to prevent the bluing of the pigment in Zn-containing glazes, a phenomenon associated with the exsolution of copper. Furthermore, doping with lanthanide oxides was explored to address two key challenges: controlling the formation of pinhole defects in porcelain glazes, which are linked to the destabilization of Cu+, and adjusting the IR cut-off wavelength to improve its performance as SSA.
Franklinite-zincochromite-gahnite solid solutions were prepared using ceramic or coprecipitation methods, and their pigmenting capacity as cool ceramic pigments in different glazes (double and single firing frits and porcelain frit) was studied. XRD, UV–Vis–NIR diffuse reflectance, CIEL*a*b* colour analysis, band gap measurements, and the photocatalytic degradation of Orange II were carried out to characterise the samples. The following criteria for high red colouring capacity and high NIR reflectance at the minimum Cr amount were found to be the optimal compositions for an intense reddish cool pigment: Zn(Fe1.8Cr0.2), Zn(Al1.5Cr0.5) and Zn(Al1.3Cr0.5Fe0.2)O4. All the powders showed a direct semiconductor behaviour, with a band gap of approximately 2 eV, which fell in the visible range (620 nm); the visible light photocatalysis of Orange II was moderate, but franklinite-zincochromite Zn(Fe1.8Cr0.2) stood out compared with silver orthophosphate.
Cuprate delafossite phases such as CuMnO2 (crednerite) and CuFeO2, as well as iron- and manganese-doped mcconnellite composites, were investigated as candidates for producing intense black ceramic pigments via conventional solid-state synthesis. Both electric kiln and fast dielectric (microwave) firing methods were employed, with mcconnellite (CuCrO2) used as a reference pigment. Microwave firing led to a marked improvement in sample blackness compared to conventional electric firing. Among the delafossite phases, only mcconnellite subjected to microwave-assisted firing (RVis = 1.40%, corresponding to 98.60% visible light absorption) emerges, pending further optimization, as a promising candidate for an ultra-black ceramic pigment (RVis < 1%) under optimized glaze conditions (ZnO-free) and a firing temperature of 1000 °C. Considering the pigments in powder form, microwave-fired crednerite (RVis = 4.85%, 95.15% absorption) and iron- and iron–manganese-doped mcconnellite composites (RVis = 3.27% and 3.23%, respectively) appear as potential candidates for deep-black pigments (RVis < 3%), benefiting from the composite effect between the delafossite phase and the associated chromium spinel. Moreover, microwave-fired crednerite also demonstrates noteworthy potential for deep-black coloration in glazed samples (RVis = 4.27%, 95.73% absorption).
Franklinite-Zincochromite-Gahnite solid solutions have been prepared by ceramic or coprecipitation method and its pigmenting capacity as cool ceramic pigments in different glazes (double and single firing frits and porcelain frit) was studied. XRD, UV-Vis-NIR diffuse reflectance, CIEL*a*b* colour analysis, bandgap measurement and the photocatalytic activity over the Orange II azoic dye were carried out for the characterization of samples. Following criteria of high red colouring capacity and high NIR reflectance at minimum Cr amount, Zn(Fe1.8Cr0.2), Zn(Al1.5Cr0.5) and Zn(Al1.3Cr0.5Fe0.2)O4 turn out to be the optimal compositions for an intense reddish cool pigment. All powders show a direct semiconductor behaviour with bandgap around 2 eV, falling in the visible range (620 nm), and according to literature, the associated photocatalytic activity over Orange II with visible light irradiation is moderate in all cases, but the Franklinite-Zincochromite Zn(Fe1.8Cr0.2) stands out.