Evidence points to increasing the development of floating wind turbines to unlock the full potential of worldwide wind-energy generation. Barge-type floating wind turbines are of interest because of their shallow draft, structural simplicity, and moonpool-damping effect. Based on the BEM potential flow method, this study uses ANSYS-AQWA software to create a floating-barge moonpool platform model equipped with an OC5 NREL 5 MW wind turbine, to study the effect of the damping lid method on the resonance of the moonpool gap water, the wind–wave coupling effect, and the dynamic response of the FOWT and mooring system after single-line and double-line failure. The results show that the damping lid method, based on the potential flow theory, can effectively correct the effect caused by the lack of viscosity; the effect of a single breakage of upwind mooring lines on the motion is mainly in the sway and yaw modes, and after mooring line 8 breaks, the maximum tension of the adjacent mooring line increases by 2.91 times compared to the intact condition, which is 58.9% of the minimum breaking strength; and the breakage of two mooring lines located at one corner leads to a surge drift of up to 436.7 m and a cascading failure phenomenon.

The offshore wind industry is increasingly moving towards larger turbines. The growth in rotor size and aerodynamic loads necessitates larger monopile foundations. This increased foundation height results in a monopile that exhibits pronounced slenderness and flexibility. Consequently, the fixed-bottom monopile becomes more susceptible to wave loads, which can induce nonlinear vibrations in complex wave environments. Extensive physical model experiments have been conducted in a wave tank to study the nonlinear vibration characteristics of a fixed-bottom monopile under regular wave action. The experimental results demonstrate that when the wave period is close to twice the resonant period of the model, the vibration response of the monopile increases significantly. Under these conditions, a second harmonic resonance occurs, with the amplitude of the second harmonic component being more than twice that of the fundamental (wave frequency) component. Additionally, the maximum run-up around the model exhibits a W-shaped distribution in the circumferential direction, with the highest run-up observed on the incident wave side. The wave pressure at the water surface is the greatest and increases with wave height, while the pressure below the water surface gradually increases with the measurement height.

Conventional ammonia production via the Haber–Bosch process is energy-intensive and carbon-heavy. Emerging biomass-based approaches offer a sustainable alternative but often lack rigorous system-level analysis based on actual reaction kinetics. This study presents a novel integrated process coupling biomass pyrolysis/gasification with Chemical Looping Ammonia Generation (CLAG) and waste heat recovery. Unlike previous models relying on simplified assumptions, this simulation incorporates experimental kinetic data for both N-absorption and N-desorption stages to ensure high fidelity. The system’s energy and mass flows were rigorously evaluated using Aspen Plus. Results indicate that the gasification stage is optimal at an O₂/biomass molar ratio of 0.2 and 750 °C. In the CLAG unit, a higher N-absorption temperature (1600 °C) and α-Al₂O₃/C ratio (3:3) significantly enhance ammonia yield. Under these optimal conditions, the system achieves a remarkably low energy consumption of 10.12 GJ/t-NH₃ and specific CO₂ emissions of 3.2 t/t-NH₃—a reduction of over 60% compared to traditional coal-based routes. The integration of waste heat recovery is identified as a critical factor in minimizing net energy input. This work validates the feasibility of the biomass-based CLAG process as a low-carbon, energy-efficient pathway for sustainable ammonia synthesis.