This paper presents a method how to simulate overhead DC network transmission losses that are estimated by a variable location of an electric vehicle regarding to an invariable location of a traction substation. Electric public transport infrastructure is one of the major electrical energy consumers. Electrical energy amount which is acquired due to overhead line voltage drop and current flowing through wires is dissipated in heat and considered as energy losses. The distance between an electric vehicle and a substation is a relevant aspect that influences the amount of energy losses. Overhead DC network and trolleybus system virtual Matlab/Simulink model including a resistor subsystem for transmission loss imitation was developed. Presented energetic parameter characteristics were acquired from the chosen trolleybus Skoda 24Tr Irisbus motion simulations.
15 December 2014 in Latvian Journal of Physics and Technical Sciences
The authors present a test platform for the low-power DC electric motor of a traction vehicle or a high-power motor scaled in the traction and braking modes. The load emulator of the traction drive is made using an induction motor controlled by a frequency converter. A microcontroller controls the bi-directional DC/DC converter and sends a speed reference signal to the frequency converter. The test bench is meant for determination of the power consumption by motor in various speed cycles, and will be used to demonstrate the operation of electric vehicle to students and to investigate the charging/discharging strategies of energy sources.
Applying mobile energy storage system, asynchronous electric transport energy consumption might be significantly reduced as its braking energy can be stored for repeated use instead of being dissipated in brake resistors. Owing to comparatively rapid accelerations and decelerations, supercapacitors can be very appropriate for both energy storing and supplying due to their high power density. As a matter of fact, mobile energy storage devices not only ensure the possibility to store vehicles braking energy but also contribute in supplying trolleybus drive with power in acceleration mode, thus reducing overhead DC network energy transmission losses that are variable according to the distance between trolleybus and substation. This paper presents the chosen trolleybus model Skoda 27Tr simulations both without and with supercapacitor energy storage system. Due to additional storage device weighs, trolleybus mass increase impact on drive energy consumption and transmission loss energy is studied. Optimal supercapacitor module amount for different circumstances is analyzed.
This paper describes a stationary bench simulating the traction drive of electric transport vehicles in traction, freewheeling and braking modes which is planned to investigate the drive operation with and without a supercapacitor energy storage system. The bench contains two equal coupled AC motors simulating the traction drive of surface electric transport and the traction drive load. Before the physical realization of the bench it is necessary to design its virtual model for simulations in order to make sure that it functions as needed. The simulation of the drive operation modes is performed using Matlab/Simulink software.
1 December 2012 in Electrical, Control and Communication Engineering
Majority of modern trolleybuses are equipped with AC traction drives which are able to recuperate braking energy that is reusable by applying storage systems. However, public transport infrastructure rebuilding is financially expensive and while there are no mobile or stationary energy storage systems, general solution is to transfer the braking energy to another accelerating trolleybus in the same overhead DC network section. In frames of this work, a novel Matlab model ensuring a possibility to simulate two-trolleybus motion along a common overhead line section was developed and theoretical explanation of the idea is given. Simulation examples were performed.