Gert Dorenbos

Dr. Gert Dorenbos


Research Focus & Metrics

Academic Career Length

35Years (1992-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 March 2009 in Journal of Membrane Science
Verified
Journal Article
Closed access
GDGert Dorenbos
Gert Dorenbos
YSYoshinori Suga
Yoshinori Suga

1 January 2010 in Energy & Environmental Science
Verified
Journal Article
Closed access
PDF file
GDGert Dorenbos
Gert Dorenbos
KMKei Morohoshi
Kei Morohoshi
Using dissipative particle dynamics we model phase separation within block and grafted polymers composed of hydrophobic (A) and hydrophilic, acid-containing (C) beads. The grafted polymers have their hydrophilic beads located at the end of the grafted side chains. Pore morphologies are calculated at a hydration level λ of 4 H2O molecules/C bead. Monte Carlo tracer diffusion calculations are used to model the restricted movement of water within the pore networks. For the block polymers we find that at fixed C bead fractions, or ion exchange capacity (IEC), an increase in C block length results in larger pores and increased water diffusion. For grafted polymers of equal IEC, increasing the side chain length results in a better connected pore network and increased long-range water mobility.

28 January 2011 in The Journal of Chemical Physics
Verified
Journal Article
Closed access
GDGert Dorenbos
Gert Dorenbos
KMKei Morohoshi
Kei Morohoshi
We present a simulation tool in order to predict gas permeation through heterogeneous, microphase separated structures. The method combines dissipative particle dynamics (DPD) with kinetic Monte Carlo (KMC). Morphologies obtained from DPD are mapped onto a high density grid on which gas diffusion takes place. Required input parameters for the KMC calculations are the gas solubility and gas diffusion constant within each of the pure phase components. Our method was tested and validated for permeation of H2, O2, and N2 gasses through hydrated Nafion membranes at various temperatures and water contents. We predict that membranes that contain an equal volume fraction of water, those with the highest ion exchange capacity exhibit the largest N2 and O2 permeation rates. For membranes of the same ion exchange capacity the H2, O2, and N2 and permeability increases approximately linearly with Bragg spacing. We also predict that O2 gas permeation depends much more on bottleneck phenomena within the phase separated morphologies than H2 gas permeation. Overall, the calculated H2 and O2 permeability is found to be slightly lower than experimental values. This is attributed to the robustness of DPD resulting in ∼7% larger Bragg spacing as compared with experiment and/or increased gas solubility within the polymer phase with water uptake.

13 February 2013 in The Journal of Chemical Physics
Verified
Journal Article
Closed access
GDGert Dorenbos
Gert Dorenbos
KMK. Morohoshi
K. Morohoshi
Using dissipative particle dynamics pore morphologies within model ionomer membranes are simulated. The ionomers are composed of hydrophobic backbones and side chains that are end-linked with a hydrophilic acid containing site. The separation distance between successive branching points is bi-modal, being alternating short (distance x) and long (distance y). The dependence of morphology on ion exchange capacity and separation distance is investigated. Phase separated morphologies were calculated at a water content of 16 vol. %. An increase of side chain density results in a decreasing size of the water containing pores, distance between them and decreasing Bragg spacing. For fixed side chain density, an increase in difference between the longer and shorter separation distance (y − x) results in a larger Bragg spacing. Monte Carlo calculations demonstrate that a large majority of the water is contained within a percolating network that allows for long-range diffusion. Diffusion constants vary drastically with architecture: Diffusion is fastest for architectures for which the side chains are highly non-uniformly distributed (y ≫ x). For architectures with the same side chain density, the tracer diffusion constants increase linearly with increase of the asymmetry ratio y/x (y > x). This is caused by the cooperative action of those terminal acidic sites that are topologically close together, allowing them to arrange pair wise along the pore walls and make the pores larger. We verified that for polymer architectures that mimick Nafion1200 similar trends are obtained, resulting in increased H2O, O2, and H2 permeation for statistical side chain distribution as compared to a uniform distribution of side chains. This trend is most pronounced for H2O and less pronounced for H2.

31 January 2010 in Electrochemistry Communications
Verified
Journal Article
Closed access
GDGert Dorenbos
Gert Dorenbos
VPVladimir Pomogaev
Vladimir Pomogaev
MTM. Takigawa
M. Takigawa
KMK. Morohoshi
K. Morohoshi

15 January 1993 in Physical Review B
Verified
Journal Article
Closed access
PDF file
GDGert Dorenbos
Gert Dorenbos
MBM. Breeman
M. Breeman
DBD. O. Boerma
D. O. Boerma
The oxygen-induced Cu(110)-p(2×1)O and Cu(110)-c(6×2)O surfaces were studied by means of low-energy ion scattering combined with time of flight. The surfaces were bombarded with 6-keV Ar ions and azimuthal scans for recoiled O and Cu were compared with Monte Carlo computer simulations. The ‘‘added row’’ model for the p(2×1) structure is confirmed in this work. The oxygen atoms were found to be located in the [100] bridge position, 0.05±0.06 Å below the Cu atoms. The recently proposed structure for the c(6×2) surface was confirmed by our data and information about the z positions of the O and Cu atoms was obtained. The topmost ‘‘superstructure’’ Cu and O atoms are located 0.45±0.12 Å and 0.40±0.12 Å above the underlying Cu layer, respectively. The remaining O atoms are located in the [100] bridge positions 0.12±0.12 Å below the Cu atoms.