Mechanical cooling of the entire mining tunnel, widely used in deep coal mines, has a significant energy-intensive consumption, particularly for intelligent mining tunnels. Therefore, localized cooling would benefit the intelligent mining industry. Current studies on the temperature, relative humidity, and air velocity under localized cooling for working protection are still unclear. A modified predicted heat strain model that is appropriate for warm and humid conditions is presented in this article and calculated using MATLAB. Results reveal that air temperature was the primary factor affecting underground miners’ safety. Increasing air velocity would improve the working environment when the thermal humidity index is lower than 32. Reducing total working time and wet bulb temperature would benefit underground miners’ security. For the cooling of intelligent mining tunnels, the recommended air velocity would be 2 m/s, and the maximum wet bulb temperature would be 28 °C for the 6-h working period and 26 °C for the 8-h working period. Results would be beneficial to the cooling of intelligent mining in China.

In this paper, numerical simulations of a special energy pile, which constitutes a spiral-injected pipe and one straight discharge pile for Geothermal Heat Pump Systems (SGHEs-P(parallel)), were conducted by Fluent software. The effects of the spiral pitches on the heat transfer rate based on the G-function method and peripheral soil temperature of the pile were investigated under continuous and intermittent operation strategies. The impact of spiral tube sizing on the surface heat transfer coefficients was studied. The results indicated that SGHEs-P may be preferred for office buildings under intermittent operation conditions. For a short period, the temperature profiles and heat transfer efficiency of SGHEs-P were mainly influenced by the fluid type, length of the spiral tube, and spiral pitch. The smaller the spiral pitch, the more uniform the temperature distribution, and the better the heat transfer effect, but the heat transfer per unit depth of pile decreased. The average temperature variation curve of the soil around the energy pile with different spiral pitches was simulated and obtained over time. Meanwhile, the impact of spiral radius, spiral pitch, and spiral tube radius on the convective heat transfer coefficient was also presented. Through data fitting, the formulas for the correction coefficients of spiral radius, spiral pitch, and spiral tube radius on convective heat transfer coefficient were obtained, respectively.

In order to solve the problems of time consuming, energy consumption and low simulation accuracy in the hot air-drying system of food drying. Using computational fluid dynamics (CFD) to simulate the drying process of mushrooms can provide a reference for its technology research and development (R&D). The porous media approach was used to model the flow resistance offered by the mushroom. The resistance coefficient and porosity were determined through the experiments. Different air supply ways (wind speed, temperature, fresh air volume, reverse air supply period) were simulated and two optimize ways were suggested according the shortest possible drying time. The simulation results are in good agreement with the experimental results. The air supply way of periodic with reverse (SMPR), which means timed alternate the direction of air flow, or the way of mix in fresh air intermittently can effectively shorten the drying time. Considering comprehensively, the optimal air supply way was the mix in fresh air intermittently with fresh air accounts for 30% or SMPR with the period of 2h under the condition of the hot air temperature of 55°C and wind velocity of 0.6m/s.