The effect of temperature variation along a high-power fiber amplifier on the stimulated Brillouin scattering (SBS) threshold is considered theoretically. We show that for an end-pumped rare-earth-doped double-clad fiber the inhomogeneous distribution of temperature, which is caused by the absorption of pump radiation, may result in total suppression of SBS even for output powers well above .
We show that in optical fiber the threshold exponential gain, Gth, for stimulated Brillouin scattering initiated by spontaneous Brillouin scattering is functionally and strongly dependent on the material, length and numerical aperture of the fiber and the pump wavelength. For silica fiber we show that the value of Gth at λ≅1 µm ranges from as low as ~5 in long fiber (≥ few kms) to ~10–12 in fibers of ~100 m length and ~20–23 for very short fibers (<10 cm).
An analytical solution of the basic coupled stimulated Brillouin scattering (SBS) equations is obtained which describes the evolution of a Stokes pulse injected into an extended Brillouin medium excited by CW pump radiation. We show that regardless of the pulse length of the input Stokes pulse the delay of the output Stokes pulse results entirely from the inertia of the acoustic wave excitation via the electrostrictive interaction of the Stokes pulse with CW pump radiation. This delay is the SBS build up time and not the SBS induced group delay normally attributed to slow light.
An analytical solution of the basic coupled stimulated Brillouin scattering (SBS) equations is obtained in the Fourier domain, which describes the spectral evolution of the medium's response, and that of a Stokes pulse injected into this medium, when SBS is excited by non-monochromatic CW pump radiation. It shows that spectral broadening of pump radiation by any reasonable amount results in only minute increase of the spectral width of the resonant material's excitation in SBS, and cannot be effective in modifying the natural group index of the medium for the Stokes pulse.