Various spherulites or spherulitic crystals are widely encountered in polymeric materials when crystallized from viscous melts or concentrated solutions. However, the microstructures and growth processes are quite complicated and remain unclear and, thus, the formation mechanisms are rather elusive. Here, diverse kinds of spherulitic growths and patterns of typical polyesters via evaporative crystallization of solution-cast thin films are delineated after detailed investigating the microstructures and in situ following the developing processes. The spherulitic crystals produced under different evaporation conditions reflect variously optical features, such as the usual Maltese Cross, non-birefringent or half-birefringent concentric-rings, extinction spiral banding, and even a nested ring-banded pattern. Polymer spherulites are composed of stacks of radial fibrillar lamellae, and the diversity of bewitchingly spherulitic morphologies is dominated by the arrangement and organization of radial lamellae, which is predicted to be tunable by modulating the evaporative crystallization processes. The emergence of various types of spherulitic morphologies of the same polymer is attributed to a precise manipulation of the radial lamellar organization by a coupling of structural features and specific crystal evolving courses under confined evaporation environments. The present findings improve dramatically the understanding of the structural development and crystallization mechanism for emergence of diverse polymer spherulitic morphologies.
An in situ small-angle X-ray scattering (SAXS) study of the structural effects of temperature and draw ratio (DR1) of the hot-drawing process on ultra-high molecular weight polyethylene (UHMWPE) gel fibers was performed with equipment simulating the hot-drawing process on an industrial production line. The UHMWPE gel fibers were prepared from the industrial production line. The results show that the increase of hot-drawing temperature has a significant effect on the kebab but no obvious effect on shish length and misorientation. The increase of temperature is beneficial to the formation of the shish in a suitable temperature range of 124–130 °C, while the formation of the shish at higher temperature, 140 °C, needs higher DR1. Moreover, the increase of DR1 is beneficial to the formation of shish at all experimental hot-drawing temperatures, while the kebab formation mainly occurs at low DR1 and the kebab transformation mainly happens at high DR1. The shish length and misorientation decreases with the increase of DR1.
22 July 2016 in Industrial & Engineering Chemistry Research