Hydrogen prepared by electrocatalytic decomposition of water (“green hydrogen”) has the advantages of high energy density and being clean and pollution-free, which is an important energy carrier to face the problems of the energy crisis and environmental pollution. However, the most used commercial electrocatalysts are based on expensive and scarce precious metals and their alloy materials, which seriously restricts the large-scale industrial application of hydrogen energy. The development of efficient non-precious metal electrocatalysts is the key to achieving the sustainable development of the hydrogen energy industry. Transition metal sulfides (TMS) have become popular non-precious metal electrocatalysts with great application potential due to their large specific surface area, unique electronic structure, and rich regulatory strategies. To further improve their catalytic activities for practical application, many methods have been tried in recent years, including control of morphology and crystal plane, metal/nonmetal doping, vacancy engineering, building of self-supporting electrocatalysts, interface engineering, etc. In this review, we introduce firstly the common types of TMS and their preparation. Additionally, we summarize the recent developments of the many different strategies mentioned above for efficient water electrolysis applications. Furthermore, the rationales behind their enhanced electrochemical performances are discussed. Lastly, the challenges and future perspectives are briefly discussed for TMS-based water dissociation catalysts.

The copper/aluminum (Cu/Al) clad sheets were produced on a horizontal twin-roll caster and then were multi-pass rolled and annealed. The thickness of the as-cast clad sheet was 8 mm. Rolling was performed with total reductions of 12.5%, 25%, 37.5%, 50%, and 62.5%, separately. The effects of the rolling and annealing processes on the interface and peel strength of the Cu/Al clad sheets were investigated. The evolution of the interface and crack propagation were studied. The interface thickness of the as-cast clad sheet reached 9 μm to 10 μm. The average peel strength (APS) was only 9 N/mm. After multi-pass rolling, the peel strength first slightly increased and then gradually decreased with the increase of the rolling pass number. After annealing, the peel strength remarkably improved. The APS reached 25 N/mm when the rolled thickness was 7 mm. The improvement in the peel strength was due to the following three factors: (1) mechanical locking formed in the Cu/Al direct contact region after rolling, (2) the region of the Al matrix fracture, and (3) mechanical biting from the Cu/Al direct contact region.