The practical application of BFRPB (Basalt Fiber-Reinforced Polymer Bars) as a support structure in foundation pit and slope engineering is relatively under-researched. The indoor tensile test presented in this paper is carried out on the bond between BFRPB and different labelled concrete. The mechanical characteristics of BFRPB, the failure characteristics, and the load-carrying capacity were analyzed. The results of this study demonstrate that the normal section stress of concrete cylindrical components with BFRP has a good linear relationship and supports the rationality of the flat section assumption. In circular reinforced concrete BFRP structures, the failure of the pile load occurs in four phases, and the cracking load is in the range of 51% to 67% of the normal yield load. The main bars increase in strain with load but become attenuated in the compression zone. The deformation of the main bars increases with the load but becomes muted in the compression zone. Based on the method of calculating the load-carrying capacity of GFRP-reinforced RC piles and the normal limit load-carrying moment obtained from in-door tests, the bending moment correction coefficient in the calculation formula for the load-carrying capacity of BFRP-reinforced RC piles was then obtained.

Horizontal resistance can be significantly different for gravelly soil slope sites with different gradients. The impact of slope gradient on the horizontal resistance of soil based on a three-dimensional physical simulation test has been investigated, and the displacement of the pile top and soil pressure for four piles under various gradients (slope gradient 0–45°) was analyzed. The research reveals that ① The soil resistance exhibits a linear increase stage, non-linear steep increase stage, and gradually stabilizing stage with the increase in load. ② The ultimate soil resistance is significantly affected by depth and displacement, and hyperbolic variation characteristics related to the displacement stage. It has a slope weakening effect, and the steeper the slope gradient, the lower the ultimate soil resistance of the pile sides, which effect is negligible when the depth exceeds 0.6–0.7 times that of the pile buried depth. ③ Based on the characteristics of horizontal ultimate resistance-displacement-depth variation in soil, a gradient factor, which is only related to the slope gradient, was used to describe the impact of gradient on the soil resistance modulus (k_ini) and ultimate resistance (p_u). k_ini is reduced close to the ground surface and gradually increases with depth until it becomes equal to the value of level ground. The ratio between p_u in slope ground and level ground was determined for slope angles. The above horizontal resistance parameters were expressed as a function based on the test data to calculate the lateral ultimate bearing capacity of gravelly soil considering the slope gradient factor. The research results developed the theory of foundation design for building structures, promoting the reliability evaluation of pile soil systems towards a more scientific and rigorous direction.