The influence of direct current interference on the corrosion behavior of HRB400 and HRB400M steel bars in simulated concrete solution was studied using methods such as weight loss experiment, electrochemical experiment, surface technology and product analysis. The research results showed that with the increase of DC interference voltage, the corrosion rates of HRB400 and HRB400M steel bars would increase. The corrosion resistance of HRB400M steel bars was better than HRB400 steel bars under the experimental conditions. In addition, direct current interference could cause damage to the corrosion product layer on the surface of HRB400 steel bars and HRB400M steel bars. And the corrosion form and corrosion product types of HRB400 and HRB400M steel bars would be affected by direct current interference. The main corrosion products of HRB400 steel bars included γ-FeOOH and Fe2O3 when it was not interfered by DC. When DC interference was applied, the main corrosion products included Fe3O4 and Fe2O3. The corrosion products on the surface of HRB400M steel bars were mainly Fe3O4 and Fe2O3, and the types of products increased to form Cr2O3 and MnFe2O4.
29 April 2021 in International Journal of Chemical Engineering
The influence of ultraviolet rays on the corrosion behavior of 7075 aluminum alloy in the marine atmosphere was studied by salt spray corrosion test. Electrochemical methods and surface analysis techniques were used to analyze and compare the corrosion laws of 7075 aluminum alloy in the marine atmosphere under ultraviolet radiation with wavelengths of 0 nm, 185 nm, 254 nm, and 365 nm. The results showed that ultraviolet light irradiation could promote the corrosion of 7075 aluminum alloy. Oxygen was prone to chemical reactions to form oxygen atoms after being irradiated by ultraviolet rays, and oxygen atoms recombined with oxygen to form ozone in the marine atmosphere. The 7075 aluminum alloy in the marine atmosphere accelerated corrosion due to the increasing ozone content. Although there were passivation films with different degrees of protection on the surface of aluminum alloy under ultraviolet irradiation, the surface of 7075 aluminum alloy in the marine atmosphere failed to form a stable passivation film after pitting, and the corrosion rate was the fastest when the ultraviolet wavelength was 185 nm.