The recovery of scheelite from calcium-bearing carbonate ores by foam flotation is challenging due to its low separation efficiency. This study investigated the effect of pentasodium diethylenetriaminepentaacetate (PD) on the surface properties of scheelite and fluorite. For this purpose, we performed micro-flotation tests and carried out zeta potential measurements, as well as Fourier transform infrared (FT-IR) and X-ray photoelectron (XPS) spectroscopic measurements, in order to analyze the surface properties of these minerals. The addition of PD as a novel depressor significantly improved the effect of fluorite and sodium oleate (NaOl) on the flotation-based scheelite recovery and separation from fluorite. PD was spontaneously adsorbed onto fluorite through electrostatic and chemical adsorption. By contrast, PD did not appear on the scheelite because of the reaction conditions, surface site, and steric hindrance. X-ray photoelectron spectroscopy measurements and a solution chemistry analysis were used for the determination of the PD-selective adsorption mechanism and key factors derived from multi-layer adsorption onto fluorite, which completely hindered that of NaOl.
To improve the separation efficiency of raw coal and ensure clean use, the accurate calculation of the partition coefficients (PCs) in coal water medium sorting is required. Single models have been used to predict the partition coefficient (PC) for decades, but their accuracy remains constrained. This study proposes a multi-model (MM) calculation method based on the Gompertz model (GM), the Logistic model (LM), the Arctangent model (AM), and the Approximate formula (AFM) to improve the accuracy of the predicted coal water medium sorting PCs. Four groups of coal samples and two specific cases were used to verify the accuracy of the MM calculation method. The PCs of the MM method had a minimal Ef (0.91-8.84), a maximal R2 (0.9648-0.9994), a maximal F-value (199.17-11352.31), and the highest significance of all the models. The MM method was found to be the most suitable of all the models for predicting any coal water medium separation process. Further, when calculating the PC for cleaned coal ash, the separation density of MM is closer to the actual separation density than that of either the GM, LM, AM, or AFM models. The MM method, therefore, produces more accurate results compared to a single model. MM is expected to predict the PC based on the required cleaned coal ash, and then regulate the sorting density to improve the production efficiency.
Heavy metal ions in wastewater endanger ecology and human health, requiring cost-effective treatments. This study innovatively converts abandoned basalt fibers (BFs) into high-performance adsorbents (BFSN) via NaOH etching and chelation with nitrilotriacetic acid (NTA)/carboxymethyl starch (CMS), introducing target functional groups. Characterizations (XPS, FTIR, zeta potential) reveal Cu2+/Pb2+ adsorption mechanisms: -COO− chelation, N-containing group ion exchange, and electrostatic adsorption. Kinetics fit a pseudo-first-order model (R2 > 0.98) and isotherms fit the Langmuir model, confirming monolayer chemisorption. BFSN has excellent thermal stability (≤2% mass loss at 800 °C) and post-adsorption integrity (≈0.11% mass loss post-loading). Waste-derived BFSN, cheaper than commercial adsorbents, has strong economic viability. This “waste-to-value” approach offers efficient, sustainable large-scale heavy metal wastewater remediation, advancing waste utilization and ecological restoration in water treatment.