Electric vehicles (EVs), which are environmentally friendly, have been used to minimize the global warming caused by fossil fuels used in vehicles and increasing fuel prices due to the decrease in fossil resources. Considering that the energy used in EVs is obtained from fossil resources, it is also important to store and use energy efficiently in EVs. In this context, recovery from a regenerative braking system plays an important role in EV energy efficiency. This paper presents a fuzzy logic-based hybrid storage technique consisting of a supercapacitor (SC) and battery for efficient and safe storage of a regenerative braking system. First, the constraints of the battery to be used in the EV for fuzzy logic control are identified. Then, the fuzzy logic system is created and tested in the ADVISOR and Siemens Simcenter Flomaster programs in the New European Driving Cycle (NEDC) driving cycle. A SC was selected for primary storage to prevent the battery from being continuously charged from regenerative braking, thus reducing its lifetime. In cases where the vehicle consumes more energy than the average energy consumption, energy consumption from the battery is reduced by using the energy stored in the SC, and the SC energy is discharged, making preparations for the energy that will come from the next regenerative braking. Thus, the high current values transferred to the battery during regenerative braking are effectively limited by the SC. In this study, the current values on the battery in the EV with a hybrid storage system decreased by 29.1% in the ADVISOR program and 28.7% in the Simcenter Flomaster program. In addition, the battery generated 46.84% less heat in the hybrid storage system. Thus, the heating and capacity losses caused by this current on the battery were minimized. The presented method provides more efficient energy management for EVs and plays an important role in maintaining battery health.
25 April 2019 in Macromolecular Materials and Engineering
Estimation of the wind speed makes a very important contribution to the seamless integration of wind power plants into the grid. In this way, the maximum amount of electricity can be generated by estimating the amount of energy that can be generated from wind energy. The measurements of the wind speed in the region, where the plant is plant to be established, made before the installation of the wind power plants (WPP), takes between 6 and 18 months. In this study, it was investigated what could be done to make a foresight and estimation about the wind speed in the future for the selected region. In order to accurately determine the wind speed, it was tried to be estimated by using artificial neural networks (ANN) included in the MATLAB package program. In this study, 365 data belonging to the previous years of the region to be studied were provided and used to train the ANN of the planned study. In practice, the parameters of temperature, humidity and pressure, which are among the factors affecting wind speed, were taken into consideration. An R value of 91.20% in the training phase, 93.04% in the validation phase and 92.76% in the test phase was obtained. High accuracy values were obtained at all phases and it was shown in this study that ANN can estimate reliably without memorizing.
In Diesel Engines, the heat energy obtained from the glow plug increases the engine's ability to start up in cold climatic conditions and significantly reduces emissions of harmful gases leaving the exhaust. In cold climatic conditions, before the start off of diesel vehicles it is necessary to wait for about 10 s the cylinder block heating. This period negatively affects driving comfort. In this study, the mathematical results of the processes to optimize the time required for the glow plug to reach the required temperature have been experimentally proven. A test apparatus was developed to confirm experimentally the theoretical results. Thanks to these improvements concerning the manufacture of the glow plug, the time period to reach 850 ° C has been reduced by approximately 5 s. The proposed design is in accordance with the glow plug present in the market. Currently the whole glow plug must be changed at the end of lifetime, with our improvement only the inner tube resistance can be easily changed involving a cost reduction by about 60%.