This review explores the development of spin-wave technology, highlighting magnonics as a promising route for radio frequency (RF) communication systems. The rollout of 5G and the upcoming 6G networks intensifies the demand for devices that can operate at higher frequencies while remaining scalable, compact, and energy-efficient—requirements that spin waves are well suited to meet. The first two sections revisit the fundamentals of magnonics, trace major milestones in spin-wave research, and summarize recent advances in materials and device design. The third section reviews RF applications studied over the past 50 years, with emphasis on key passive components, such as filters, limiters, delay lines, phase shifters, and directional couplers. The final section discusses both the advantages and the open challenges of spin-wave devices, including insertion loss, linearity, and power handling, together with the strategies to address them. By linking fundamental insights with technological needs, this review outlines a path toward practical RF platforms. Spin-wave-based devices, with their scalability, versatility, and potential for low-power operation, hold strong promise for future wireless communication, particularly in the 5G and 6G era.
9 July 2014 in IEEE Microwave and Wireless Components Letters
This letter proposes a UWB pulse generator topology featuring low peak power dissipation for applications with stringent instantaneous power requirements. This is accomplished by employing a new slow-charge fast-discharge approach to extend the time duration of the generator's peak current so that the peak value of the current is significantly reduced, while maintaining the waveform of the generated UWB pulse signal. A prototype pulse generator has been implemented using the UMC 0.18 μm CMOS process for validation. The pulse generator offers a 3-10 GHz bandwidth, a maximum pulse repetitive rate of 1 Gpps, a minimum peak power consumption of 6 mW, and a low energy consumption of 5 pJ/pulse. The fabricated pulse generator measures 0.16 mm 2 .
14 May 2015 in IEEE Transactions on Circuits and Systems II: Express Briefs
This brief presents an ultra-wideband pulse generator topology featuring adaptive control of power spectral density for a broad range of applications with different data rate requirements. The adaptivity is accomplished by employing a limited monocycle precharge approach to control the energy used for pulse generation at different desired data rates. By doing so, the need for tuning circuits is eliminated and the radiated power is maintained at the highest level allowed by the Federal Communications Commission. A prototype pulse generator has been implemented using the UMC 180-nm CMOS process for validation. The measured results show that the pulse generator can be used for a wide pulse repetition rate range from 100 Mpps to 1 Gpps. In addition, the pulse generator consumes 0.76 pJ/pulse at 1 Gpps, equivalent to 760 μW and has a compact size of 0.09 mm 2 .
A 0.18 mum CMOS low power ring VCO for 3-5 GHz FM-UWB system applications is presented. In order to achieve a 1 GHz ultra-wide tuning range while retaining a low power consumption the conventional ring configuration is modified. A detailed analysis of the proposed VCO configuration is presented in terms of oscillating frequency, control performance and phase noise performance. During the design phase several tradeoffs were made between power consumption, phase noise and tuning range. Measurement shows that the proposed VCO configuration can provide a tuning range of 1.4 GHZ at 2.7-4.1 GHz while offering a -70 dBc/Hz phase noise level at a 1 MHz frequency offset. The VCO furthermore shows a good tuning linearity. In total the circuit consumes 9.5 mW