Carbonate reservoirs pose unique challenges to the petroleum industry. Research during the last decade has shown the potential for application of principles of nanoscience and technology toward solving a variety of problems faced by the petroleum industry today. The authors investigated the effectiveness of nanofluids of silane coated silica nanoparticles as in situ reservoir agents. Effects of salinity of dispersing medium and concentration of nanoparticles on particle size and surface zeta potential were studied to characterize the stability of nanofluids. Carbonate core samples were taken from an Indian carbonate reservoir and their wettability was restored. Contact angle measurements were made before and after the application of nanofluid to investigate the alteration in wettability. Particle size measurements showed agglomeration of nanoparticles. It was found that the extent of agglomeration was affected by salinity of the dispersing medium and concentration of nanoparticles. Wettability studies indicated that nanofluids of silane coated silica can affect wettability change toward a more water wet state. Around 2 g/L was found to be the optimal concentration for affecting wettability change.
This work is aimed at addressing surface modification of berea sandstone by silica nanofluids (NFs). Three types of nanofluids were used: silica/deionized water (DIW), silica in DIW with a stabilizer fluid (3-Mercaptopropyl Trimethoxysilane) and sulfonate-functionalized silica in DIW. Core flood studies showed that application of silica nanoparticles (NPs) improved water injectivity in sandstone. The change in the measured zeta potential indicated surface modification of sandstone by application of NPs. Computation of the surface forces showed that the modified berea sandstone has net attractive potential with fines (obtained from water/rock interaction) leading to reduction of fines migration, hence improvement of water injectivity. It was also observed that the silica NPs have greater affinity to adhere/adsorb on quartz surfaces than kaolinite in berea core. This was confirmed by scanning electron microscope imaging and isothermal static adsorption tests. Although the stabilizing of NFs almost did not reduce the fine migration, as was qualitatively indicated by the pressure drop, it enhanced the NPs adsorption on the minerals as obtained by isothermal static adsorption tests. The reduction of fines migration due surface modification by silica NP suggests that NPs can be utilized to overcome the problem of formation damage induced during low salinity flooding in sandstones.
This study addresses the kinetics of silica nanoparticle adsorption on calcite from a solution at three salinities: deionized water (DIW), synthetic seawater (SSW), and low salinity water (LSW). The nanoparticle adsorption mechanisms and the effects on calcite dissolution are addressed. It was shown that nanoparticle adsorption was best described with the second-order-kinetic model and that silica nanoparticle adsorption reduced calcite dissolution. This was confirmed by measuring the Ca2+ ion concentration, the pH, and by estimating the amount of calcite dissolved. This is an important conclusion of this work, especially as LSW as an enhanced oil recovery technique is a candidate for use in chalk fields. Less formation damage/dissolution of chalk when silica nanoparticles are combined with LSW can lower the risk of reservoir subsidence. Intraparticle diffusion and the pseudo-second-order models, indicated a reduction in the adsorption rate with increasing nanoparticle concentration in LSW. This is explained by possible repulsive forces among the nanoparticles as they diffuse from the bulk fluid onto the calcite surface. Ion charges reduce the repulsion among the nanoparticles through shielding. However, an increasing nanoparticle concentration reduces the shielding efficiency by the ions. Estimates of the surface forces confirmed that nanoparticle–mineral interaction is less attractive in LSW as compared to SSW and DIW.
The main objective of this work is to address the adsorption of Silica nanoparticles (NPs) dispersed in different brines on chalk surfaces and their effect on fluid/rock interaction. Isothermal static and dynamic adsorption on chalk are addressed here. Isothermal static adsorption showed increased adsorption of NPs at higher salinity. The tests were performed to cover wide range of injection scenarios with synthetic seawater (SSW) and low salinity water (LSW). The selected LSW composition here is based on 1:10 diluted SSW, which has shown to have superior performance compared to other ion compositions. The dynamic adsorption tests of NPs showed reduction of calcite dissolution of about 30% compared to LSW alone. That is, silica nanofluid hinders calcite dissolution i.e., has less effect on chalk matrix integrity which is a major concern in chalk reservoir, if low salinity is employed for enhanced oil recovery. Both scanning electron microscope images and pressure drop across the core during nanofluid injection indicated no throat blockage. Based on ion tracking and the monitored pH, the mechanism(s) for NP adsorption/desorption are suggested. The results from this study suggests a synergy wherein adding relatively small amount of silica NPs can improve the performance of low salinity floods.
This study addresses adsorption kinetics of silica nanoparticles on sandstone mineral surfaces and Enhanced oil recovery (EOR) by nanoparticles. It was shown that nanoparticle adsorption on quartz which is the major constituent of sandstone reservoirs was best described as second order process. Both rate and equilibrium adsorption increases with salinity. However, salinity reduces Intraparticle diffusion while enhancing film diffusion. Spontaneous imbibition with nanoparticles dispersed in low salinity water showed higher incremental recovery which may be due to increased structural disjoining pressure. This was supported by surface forces analysis based on particle size and zeta potential measurements of the nanofluids.