Simultaneous localization and mapping (SLAM) is one of the key technologies for mobile robots to achieve autonomous driving, and the lidar SLAM algorithm is the mainstream research scheme. Firstly, this paper introduces the overall framework of lidar SLAM, elaborates on the functions of front-end scan matching, loop closure detection, back-end optimization, and map building module, and summarizes the algorithms used. Then, the classical representative SLAM algorithms are described and compared from three aspects: pure lidar SLAM algorithm, multi-sensor fusion SLAM algorithm, and deep learning lidar SLAM algorithm. Finally, the challenges faced by the lidar SLAM algorithm in practical use are discussed. The development trend of the lidar SLAM algorithm is prospected from five dimensions: lightweight, multi-sensor fusion, combination of new sensors, multi-robot collaboration, and deep learning. This paper can provide a brief guide for novices entering the field of SLAM and provide a comprehensive reference for experienced researchers and engineers to explore new research directions.
Intelligentization is the development trend of the future automobile industry. Intelligentization requires that the dynamic control of the vehicle can complete the trajectory tracking according to the trajectory output of the decision planning the driving state of the vehicle and ensure the driving safety and stability of the vehicle. However, trajectory limit planning and harsh road conditions caused by emergencies will increase the difficulty of trajectory tracking and stability control of unmanned vehicles. In view of the above problems, this paper studies the trajectory tracking and stability control of distributed drive unmanned vehicles. This paper applies a hierarchical control framework. Firstly, in the upper controller, an adaptive prediction time linear quadratic regulator (APT LQR) path following algorithm is proposed to acquire the desired front-wheel-steering angle considering the dynamic stability performance of the tires. The lateral stability of the DDAUV is determined based on the phase plane, and the sliding surface, in the improved sliding mode control (SMC), is further dynamically adjusted to obtain the desired additional yaw moment for coordinating the path following and lateral stability. Then, in the lower controller, considering the slip and the working load of four tires, a comprehensive cost function is established to reasonably distribute the driving torque of four in-wheel motors (IWMs) for producing the desired additional yaw moment. Finally, the proposed control algorithm is verified by the hardware-in-the-loop (HIL) experiment platform. The results show the path following and lateral stability can be coordinated effectively under different driving conditions.
Simultaneous localization and mapping (SLAM) is one of the key technologies for mobile robots to achieve autonomous driving, and the lidar SLAM algorithm is the mainstream research scheme. Firstly, this paper introduces the overall framework of lidar SLAM, elaborates on the functions of front-end scanning matching, closed-loop detection, back-end optimization, and map building module, and summarizes the algorithms used. Then, the classical representative SLAM algorithms are described and compared from three aspects: pure lidar SLAM algorithm, multi-sensor fusion SLAM algorithm, and deep learning lidar SLAM algorithm. Finally, the challenges faced by the lidar SLAM algorithm in practical use are discussed. The development trend of the lidar SLAM algorithm is prospected from five dimensions: lightweight, multi-sensor fusion, combination of new sensors, multi-robot collaboration, and deep learning. This paper can provide a brief guide for novices entering the field of SLAM, and provide a comprehensive reference for experienced researchers and engineers to explore new research directions.