Increasing demand to deposit dense and oxidation-resistant bond coats requires reliable and efficient deposition techniques. High-Velocity Air-Fuel (HVAF), among other thermal spray processes, is showcasing consistent potential to optimize spraying techniques and deposition strategies for depositing NiCoCrAlY coatings. NiCoCrAlY coatings are sensitive to high-temperature oxidation, and preserving the aluminum reservoir in the bond coats is of the highest priority to potentially resist oxidation during thermal cycling. Contrary to the existing literature on comparing carbide-based HVAF deposition with other processes, this work investigates the specific role of nozzle configurations. It primarily focuses on in-flight particle characteristics using diagnostic tools and the corresponding inflight particle oxidation of NiCoCrAlY feedstock. This work details individual splat and coating characteristics, revealing the significant influence of nozzle configurations. A comprehensive understanding of process–material–microstructure correlations was established using a commercially available NiCoCrAlY coating system. Comprehensive discussions on nozzle configurations over various feedstock powder characteristics were carried out in this work. Advanced characterization techniques were employed to assess the in-flight particle oxidation and coating microstructure using focused ion beam (FIB), scanning electron microscopy (SEM), and energy dispersive spectroscopy (EDS).

Aircraft gas turbine blades operate in aggressive, generally oxidizing, atmospheres. A solution to mitigate the degradation and improve the performance of such components is the deposition of thermal barrier coatings systems (TBCs). High-velocity air fuel (HVAF) is a very efficient process for coating deposition in TBC systems, particularly for bond coats in aerospace applications. However, its low-temperature variant has received little attention in the literature and could be a promising alternative to limit oxidation during spraying when compared to conventional methods. This study has the main objective of analyzing how the geometry of the low-temperature HVAF gun influences the microstructure and the in-flight oxidation of MCrAlX coatings. To that end, a low-temperature HVAF torch is used to deposit MCrAlX coatings on a steel substrate with different nozzle lengths. In-flight particle diagnosis is used to measure the MCrAlX particle velocity, and to correlate to the nozzle geometry and to analyze its influence on the final coating. The microstructure of the coatings is assessed by scanning electron microscopy (SEM) and the material oxidation is analyzed and measured on a field emission scanning transmission electron microscope (FE-STEM) equipped with focused ion beam (FIB) and by Energy Dispersive Spectroscopy (EDS).

The main objective of this study was to use flash boiling atomization as a new method to inject suspensions with high solid content into the high-power plasma flow. The water-based suspension was prepared with submicron titanium oxide particles with an average size of 500 nm. The investigated solid concentrations were 20, 40, 55 and 70 wt%. Two plasma torches operated at 33, 70 and 110 kW were used to investigate the effect of increasing power on the deposited microstructure and deposition efficiency. At low torch power, the deposition efficiency decreased with increasing solid concentration, and deposits with a high number of unmelted particles were obtained with 70 wt% suspensions. At high torch power, the deposition efficiency increased with increasing solid concentration, and dense deposits were obtained with 70 wt% suspensions. XRD analysis was performed on all deposits to determine the distribution of rutile and anatase phases. The percentage of the anatase phase varied from 35.7% to 66.9%, depending on the power input and solid concentration.