The measurement data of single droplet evaporation experiments are often biased due to the extra heat input through the fiber suspension and the presence of thermal radiation in hot environments. This encumbers model validation for heat and mass transfer simulations of liquid droplets. In this paper, a thermal analysis of this measurement layout is presented with a coupled lumped parameter model, considering heat conduction through the suspension. The model was validated by experimental data from the literature and good agreements were found. The thermal analysis focused on fiber material and geometry, and thermal radiation properties. Calculations were performed on a broad range of ambient conditions for liquids with different volatility characteristics. Temporal squared droplet diameter- and temperature-profiles, furthermore, droplet stationary evaporation rate were used to characterize vaporization phenomena. The thermal balance of the droplet is dominated by the convective heat rate from the environment in the early stage of evaporation. The effect of heat conduction through the fiber becomes important at the end of the droplet lifetime when the droplet size is decreased. Temperature sensor suspension may seriously bias droplet temperature due to the larger thermal conductivity compared to quartz fiber. Large droplets in high-temperature environments show significant sensitivity to thermal radiation properties, which should be considered in measurements and model validation.
10 October 2023 in International Journal of Hydrogen Energy
Calculation of evaporation requires accurate thermophysical properties of the liquid. Such data are well-known for conventional fossil fuels. In contrast, e.g., thermal conductivity or dynamic viscosity of the fuel vapor are rarely available for modern liquid fuels. To overcome this problem, molecular models can be used. Currently, the measurement-based properties of n-heptane and diesel oil are compared with estimated values, using the state-of-the-art molecular models to derive the temperature-dependent material properties. Then their effect on droplet evaporation was evaluated. The critical parameters were liquid density, latent heat of vaporization, boiling temperature, and vapor thermal conductivity where the estimation affected the evaporation time notably. Besides a general sensitivity analysis, evaporation modeling in a practical burner ended up with similar results. By calculating droplet motion, the evaporation number, the evaporation-to-residence time ratio can be derived. An empirical cumulative distribution function is used for the spray of the analyzed burner to evaluate evaporation in the mixing tube. Evaporation number did not exceed 0.4, meaning a full evaporation prior to reaching the burner lip in all cases. As droplet inertia depends upon its size, the residence time has a minimum value due to the phenomenon of overshooting.