This study aims to reveal the cause of different weld formation quality for varying welding position in the GTAW (Gas Tungsten Arc Welding) of a thick-sheet aluminum alloy structure. The fluid flow characteristics of weld pools are investigated by CFD (Computational Fluid Dynamic) modeling and high-speed imaging for the climbing and flat welding positions, which correspond to the start and finish ends of the welds of the structure, respectively. Results show that the directions of gravity relative to weld pools may notably affect the fluid flows in weld pools for different welding positions. For flat welding, gravity will accelerate the fluid flow in the direction of sheet thickness only and in turn result in a high velocity downwards, which implies a good penetrating capability. Welds of good formation with smooth surface and consistent width can be produced under flat welding position. In contrast, for climbing welding, gravity will act on the molten metal in both the direction of sheet thickness and the lateral direction of the weld pool. As a result, the velocity in sheet-thickness direction is decreased, which implies a decreased penetrating capability. Meanwhile, the velocity backwards is increased in the top portion of the weld pool, which makes the molten metal apt to flow out of the weld pool. Both the decreased penetrating capability and the accelerated molten metal outflow would render the climbing welding process unstable, and result in welds of poor formation with uneven weld surface and inconsistent weld width. Based on the study, possible methods are proposed that could be used to improve the weld formation quality when welding thick-sheet aluminum alloys structures using various welding positions.

In the laser deposition of single crystal and directionally-solidified superalloys, it is desired to form laser deposits with high volume fractions of columnar grains by suppressing the columnar-to-equiaxed transition efficiently. In this paper, the influence of beam profile (circular and square shapes) and cooling conditions (natural cooling and forced cooling) on the geometric morphology and microstructure of deposits were experimentally studied in the laser deposition of a directionally-solidified superalloy, IC10, and the mechanisms of influence were revealed through a numerical simulation of the thermal processes during laser deposition. The results show that wider and thinner deposits were obtained with the square laser beam than those with the circular laser beam, regardless of whether natural or forced cooling conditions was used. The heights and contact angles of deposits were notably increased due to the reduced substrate temperatures by the application of forced cooling for both laser beam profiles. Under natural cooling conditions, columnar grains formed epitaxially at both the center and the edges of the deposits with the square laser beam, but only at the center of the deposits with the circular laser beam; under forced cooling conditions, columnar grains formed at both the center and the edges of deposits regardless of the laser beam profile. The high ratios of thermal gradient and solidification velocity in the height direction of the deposits were favorable to forming deposits with higher volume fractions of columnar grains.

Directionally solidified (DS) nickel-based superalloys are widely used in manufacturing turbine blades, which may fail due to wear and/or material loss during service. Laser metal deposition (LMD) has been considered to be a promising technology in repairing the damaged components thanks to the high temperature gradient formed, which is conducive to the growth of directional microstructure. Intergranular liquation cracking in the heat-affected zone (HAZ) has been one of the major problems in LMD of the DS superalloys. In this paper, the influences of two cooling conditions (conventional cooling and forced cooling) on the microstructure development and liquation cracks were studied for the laser deposition of a DS superalloy IC10. The experimental results showed that, as compared to the conventional cooling, both number and length of the liquation cracks in HAZ were notably reduced under the forced cooling condition. The effects of cooling conditions on temperature and stress fields were analyzed through a thermo-elastoplastic finite element analysis. It was revealed that the maximum tensile stress and high tensile stress region in the substrate were effectively minimized while using the forced cooling measure. The forced cooling on the substrates is a promising method for mitigating the liquation cracking in LMD of DS superalloys.