In this work silicon nitride (Si3N4) fibres, with diameters D50 = 300 nm, were successfully functionalised with a monolayer of γ-glycidoxypropyl trimethoxysilane (GPS) coupling agent. The surface modification was used as a method to enhance the dispersion and interfacial adhesion of the fibres in epoxy polymer composites. It is well known that strong interfacial adhesion between dispersed inorganic fibres and a polymer matrix improves the mechanical properties of the composite by providing an effective stress-transfer pathway between the matrix and the fibres. The functionalised Si3N4 fibres were dispersed into a commercial epoxy resin via tumble-mill mixing and ultra-sonication. Setting was initiated via addition of a poly-amine hardener and the composites were cured at room temperature for 24 hours. The fractured surfaces of the cured composite materials were analysed via SEM imaging and the mechanical properties of the composites were tested. The GPS-Si3N4 composites were shown to have improved bonding at the interface, which resulted in enhanced mechanical properties compared to the unfunctionalised Si3N4 composites, with improved tensile strengths and hardness values. This study shows the importance of achieving a strong interphase region between the surface of a fibre and the polymer matrix in fibre-reinforced polymer composites. GRAPHICAL ABSTRACT
In this article, we fabricated one-dimensional 0.5 vol% silicon nitride (Si3N4) fibre reinforced Alumix123 matrix composites by the powder metallurgy method. Si3N4 is a ceramic material with high strength, stiffness and low coefficient of thermal expansion. The Si3N4 used in the study is comprised of single crystal fibres with sub-micrometre diameter and length < 25 μm. The size of the fibre is smaller than the metal matrix powder allowing it to coat the metal powder before consolidation rather than forming agglomerations that might lead to pores and poor mechanical properties. We investigated the effects of Si3N4 fibre additions on the densification, hardness, elastic modulus and tensile strength. The experimental results found that the Si3N4 fibre effectively enhanced the mechanical properties of the composites at low additions. The microstructural analysis clearly shows the Si3N4 fibres in the sintered grain boundaries. The interface between the fibre and the Alumix123 matrix showed good wetting and bonding with only minimal reaction. The Si3N4 fibre reinforced Alumix123 composites have potential uses in the automobile and aerospace industries due to their improved specific mechanical properties.
Four ceria-based mesoporous oxide materials were prepared using a new vacuum impregnation (VI) templating method developed by the authors, namely, vacuum-assisted nanocasting (VAN). Two hard templates (SBA-15 and KIT-6) were employed, and products with compositions CeO2 and Ce0.9Gd0.1O1.9 (CGO) were made with each. The desired fluorite phase and composition were confirmed by powder XRD and EDS. The product structures were characterised by XRD, TEM, gas physisorption and SAXS. All products contained ordered mesoporous material in high yields. The specific surface areas (SSAs) and pore volumes of the products were determined to be high and the pore size and pore spacings related well to the templates from which the materials were synthesised. The TEM studies confirmed that the samples had a 3D pore structure, with this being the negative of the original template. The target materials were not only produced in high yields, but also displayed a porous single-crystal morphology with non-linear lattice planes. The highest SSA values and pore volumes were reported for materials impregnated using the KIT-6 template and with the CGO composition. The results suggest that VAN is an excellent and reproducible method for producing ordered mesoporous cerias and has considerable potential for wider application. All the mesoporous products showed dramatically increased reducibility in TPR experiments compared with a high-SSA nanoparticulate ceria reference. This is very promising for their potential applications in oxidation catalysts and in fuel cell components.