Calcareous sand deposits are widespread along the shoreline in tropical and subtropical regions. Microbially induced calcite precipitation (MICP) treatment is a new method for improving the soil’s stiffness and strength. The small-strain shear modulus and damping ratio of MICP-treated calcareous sand, two critical parameters for predicting the dynamic behavior of soil, are little known. This study conducts a series of resonant column tests to investigate the dynamic characteristics of MICP-treated calcareous sand, emphasizing the influence of treatment duration and confining stress on the stiffness and damping characteristics. It analyzes the relationship between the initial dynamic shear modulus and unconfined compressive strength. In addition, empirical relationships between the reference shear strain and treatment duration or confining stress are provided. The results show that the normalized shear modulus G/G₀ of MICP-cemented calcareous sand has a higher strain sensitivity than that of untreated sand, and the Hardin–Drnevich model can describe its attenuation pattern. The effective confining stress σ_c affects the degradation characteristics of the dynamic shear modulus of MICP-treated calcareous sand with a low cementation level; however, its impact decreases as the treatment duration increases. There is a linear relationship between the reference shear strain and confining stress. While the relationship between the reference shear stain and treatment duration is a power law.

Calcareous sand deposits are widely distributed along the shoreline in ropical and subtropical regions. Microbially induced calcite precipitation treatment (MICP) is a relatively new method to improve the stiffness and strength of the soil. Little is known about the small-strain shear modulus and damping ratio of MICP-treated calcareous sand, which are two crucial parameters for the prediction of the dynamic behavior of soil. A series of resonant column tests are performed to investigate the dynamic performance of MICP-treated calcareous sand, with special attention paid to the influence of treatment duration and confining stress on the stiffness and damping characteristics. The relationship between the initial dynamic shear modulus and unconfined compressive strength is analyzed. Additionally, the empirical equations of the reference shear strain between treatment duration and confining stress are given. The G/G0 of MICP-cemented calcareous sand presents a higher strain sensitivity than that of untreated sand, and its attenuation pattern can be described by Hardin-Drnevich model. The σc has an apparent effect on the degradation characteristics of the dynamic shear modulus of MICP-treated calcareous sand with a low cementation level, however, its effect decreases with the increasing treatment duration. The relationship between the reference shear strain and the treatment duration and confining stress can be described by a power and a linear formula, respectively.

One of the challenges to the analysis of interactions between soil and piles in lateral spreading is the modeling of the progress generated by excess pore pressure and soil strength and stiffness degradation. In this paper, a pile–soil interaction analysis method that introduces the thixotropic-induced excess pore pressure model (TEPP) to describe the progressive development of the stress–strain rate connection of liquefying soil is proposed. The reliability of the method was verified by comparing the calculated results with that of the shake table test. Then, the parametric analyses of soil–pile interactions were carried out. The results show that the bending moment and horizontal displacement of pile foundations increase with the increase in superficial viscosity and inclination angle of the site. The horizontal dislocation and bending moment of the pile foundation increase with the decrease in loading frequency as a result of the property of amplifying low-frequency loads and filtering high-frequency loads of liquefied soil.

The lateral pressure generated by liquefied soil on pile is a critical parameter in the analysis of soil-pile interaction in liquefaction-susceptible sites. Previous studies have shown that liquefied sand behaves like a non-Newton fluid, and its effect on piles has rate-dependent properties. In this study, a simplified pseudo-static method for liquefiable soil-pile interaction analysis is proposed by treating the liquefied soil as a thixotropic fluid, which considers the rate-dependent behavior. The viscous shear force generated by the relative movement between the viscous fluid (whose viscosity coefficient varies with excess pore pressure and shear strain rate) and the pile was assumed to be the lateral load on the pile. The results from the simplified analysis show that the distribution of bending moment is in good agreement with experiments data. Besides, the effects of various parameters, including relative density, thickness ratio of nonliquefiable layer to liquefiable layer, and frequency of input ground motion, on the pile-soil rate-dependent interaction were discussed in detail.

The lateral pressure generated by liquefied soil on pile is a critical parameter in the analysis of soil-pile interaction in liquefaction-susceptible sites. Previous studies have shown that liquefied sand behaves like a non-Newton fluid, and its effect on piles has rate-dependent properties. In this study, a simplified pseudo-static method for liquefiable soil-pile interaction analysis is proposed by treating the liquefied soil as a thixotropic fluid, which considers the rate-dependent behavior. The viscous shear force generated by the relative movement between the viscous fluid (whose viscosity coefficient varies with excess pore pressure and shear strain rate) and the pile was assumed to be the lateral load on the pile. The results from the simplified analysis show that the distribution of bending moment is in good agreement with experiments data. Besides, the effects of various parameters, including relative density, thickness ratio of non-liquefiable layer to liquefiable layer, and frequency of input ground motion, on the pile-soil rate-dependent interaction were discussed in detail.