Jincheng Huang

Dr. Jincheng Huang

orcid

Research Focus & Metrics

Academic Career Length

16Years (2011-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 July 2011 in Fuel Processing Technology
Verified
Journal Article
Closed access
JHJincheng Huang
Jincheng Huang
Lin LinLin Lin
Lin Lin
Yaodong WangYaodong Wang
Yaodong Wang
JQJianbin Qin
Jianbin Qin
TRTony Roskilly
Tony Roskilly
YYYanhua Yu
Yanhua Yu

30 September 2024 in Journal of Materials Research and Technology
Verified
Journal Article
Open access
BHBiao Huang
Biao Huang
HTHongqun Tang
Hongqun Tang
JHJincheng Huang
Jincheng Huang
JHJincheng Huang
Jincheng Huang
FPFei Peng
Fei Peng
QZQizhong Zhao
Qizhong Zhao

31 August 2024 in Micromachines
Verified
Journal Article
Open access
PDF file
BHBiao Huang
Biao Huang
HTHongqun Tang
Hongqun Tang
JHJincheng Huang
Jincheng Huang
YJYuanxiang Jia
Yuanxiang Jia
LLLiuhui Liao
Liuhui Liao
ZCZhendong Chen
Zhendong Chen
High-strength aluminium alloys are prone to porosity and cracking during laser-based powder bed fusion of metals (PBF-LB/M) due to the complex solidification behaviour, thus limiting the preparation of high-quality aluminium alloys. In order to effectively reduce the defect formation, this study investigated the influence mechanism of different process parameters on the formation of porosity and cracks in Al-Zn-Mg-Cu alloys in the PBF-LB/M process by combining experimental and numerical simulation. The degree of influence of the process parameters on the temperature field and the temperature field on the defect formation was also quantified using path analysis. The results show that modulation of the process parameters can effectively reduce the formation of cracks and pores, although it is difficult to eliminate them. The melt pool temperature has a significant effect on the formation of porosity, and the temperature gradient has a significant effect on the formation of cracks. The degree of influence of laser power on the melt pool temperature and temperature gradient was greater than that of scanning speed, with values of 0.980 and 0.989, respectively. Therefore, the priority of modulating the laser power is higher than that of scanning speed in order to reduce the formation of defects more effectively.