Airborne isocyanates were conveniently detected by a test paper loaded with a novel single fluorophore ratiometric fluorescent probe.

A ratiometric fluorescent probe (N-butyl-4-(4-amino-styryl)-1,8-naphthalimide) was developed for the quantitative detection of styrene in air. The sensing mechanism was found to involve a Heck reaction between the pretreated probe (diazotization) and styrene. A probe solution absorption method was established to detect gaseous styrene quantitatively.

In this study, a two-step method was used to realize the liquefaction of waste sawdust under atmospheric pressure, and to achieve a high liquefaction rate. Specifically, waste sawdust was pretreated with NaOH, followed by liquefaction using phenol. The relative optimum condition for alkali–heat pretreatment was a 1:1 mass ratio of NaOH to sawdust at 140 °C. The reaction parameters including the mass ratio of phenol to pretreated sawdust, liquefaction temperature, and liquefaction time were optimized by response surface methodology. The optimal conditions for phenol liquefaction of pretreated sawdust were a 4.21 mass ratio of phenol to sawdust, a liquefaction temperature of 173.58 °C, and a liquefaction time of 2.24 h, resulting in corresponding liquefied residues of 6.35%. The liquefaction rate reached 93.65%. Finally, scanning electron microscopy (SEM), Fourier transform infrared spectroscopy (FT-IR), and X-ray diffraction (XRD) were used to analyze untreated waste sawdust, pretreated sawdust, liquefied residues, and liquefied liquid. SEM results showed that the alkali–heat pretreatment and liquefaction reactions destroyed the intact, dense, and homogeneous sample structures. FT-IR results showed that liquefied residues contain aromatic compounds with different substituents, including mainly lignin and its derivatives, while the liquefied liquid contains a large number of aromatic phenolic compounds. XRD showed that alkali–heat pretreatment and phenol liquefaction destroyed most of the crystalline regions, greatly reduced the crystallinity and changed the crystal type of cellulose in the sawdust.

The Fenton reaction has been widely used in the pretreatment of lignocellulose. It offers the advantages of simple operation, fast reaction speed, and low pollution. In this study, the effects of different proportions of Fenton reagents on the enzymatic hydrolysis of poplar were compared and analyzed, and the optimal ratio of Fenton reagents was obtained. The maximum yield of enzymatic hydrolysis of glucose in Fenton pretreatment samples was 406 mg/g at H2O2 and Fe2+ concentrations of 1.0 mol/L and 0.01 mol/L, respectively, which was 2.5 times that of untreated samples. Meanwhile, the composition analysis and FT-IR analysis showed that Fenton pretreatment could degrade lignin and hemicellulose effectively. X-ray diffraction (XRD) analysis showed that Fenton pretreatment can partially destroy the amorphous region of poplar. These findings will contribute to efforts to improve the viability of the Fenton pretreatment process for converting biomass into energy.