A robotic harness optimizing gravity-dependent gait interactions enables natural locomotion across activities of daily living in people with spinal cord injury or stroke.
Transient electronics hold promise in reducing electronic waste, especially in applications that require only a limited lifetime. While various degradable electronic and physical sensing devices have been proposed, there is growing interest in the development of degradable biochemical sensors. In this work, we present the development of an organic electrochemical transistor (OECT) with degradable electrodes, printed on an eco- and bioresorbable substrate. The influence of the design and materials for the contacts, channel and gate of the transducer, namely poly(3,4-ethylene dioxythiophene):polystyrene sulfonate (PEDOT:PSS) and carbon, is systematically evaluated for the development of OECT-based transient biosensors. The sensing capabilities of the electrochemical transistors are demonstrated with ionic solutions as well as for the enzyme-based detection of glucose. The disposable OECTs show comparable performance to their non-degradable counterparts. Their integration with highly conductive degradable and printable zinc tracks is studied for the realization of interconnects. These eco-friendly OECTs may find applications as disposable and sustainable biochemical sensors, and constitute a step towards bioresorbable biosensors.
Transient electronics offer a promising solution for reducing electronic waste and for use in implantable bioelectronics, yet their fabrication remains challenging. We report on a scalable method that synergistically combines chemical and photonic mechanisms to sinter printed Zn microparticles. Following reduction of the oxide layer using an acidic solution, zinc particles are agglomerated into a continuous layer using a flash lamp annealing treatment. The resulting sintered Zn patterns exhibit electrical conductivity values as high as 5.62 × 106 S m−1. The electrical conductivity and durability of the printed zinc traces enable the fabrication of biodegradable sensors and LC circuits: temperature, strain, and chipless wireless force sensors, and radio-frequency inductive coils for remote powering. The process allows for reduced photonic energy to be delivered to the substrate and is compatible with temperature-sensitive polymeric and cellulosic substrates, enabling new avenues for the additive manufacturing of biodegradable electronics and transient implants.
Transient electronics have emerged as a new category of devices that can degrade after their functional lifetime, offering tremendous potential as disposable sensors, actuators, wearables, and implants. Additive manufacturing methods represent a promising approach for patterning transient materials, yet examples of fully printed bioelectronic devices are scarce. This study introduces a fully digital 3D printing approach enabling the prototyping and customization of soft bioelectronics made of transient materials. The direct ink writing of poly(octamethylene maleate (anhydride) citrate) (POMaC) as an elastomeric matrix and of a shellac‐carbon ink as a conductor is investigated. Precise and repeatable deposition of both structural and conductive features is achieved by optimizing printing parameters, i.e., the dispense gap, printing speed, and inlet pressure. Multi‐material 3D printing enables the fabrication of functional transient devices. Notably, pressure and strain sensors are shown to operate in ranges relevant to implanted biomechanical monitoring. 3D‐printed transient electrodes are demonstrated to be comparable to state‐of‐the‐art devices in terms of impedance behavior. Finally, physical degradation of the materials is confirmed at physiological conditions. These fully digital additive manufacturing processes enable the monolithic fabrication of customizable transient bioelectronics with adaptable functions and geometries.
27 November 2023 in Advanced Materials Technologies
We report on an eco-friendly zinc-based electrically conductive adhesive (ECA). The composition and process for the implementation of the paste to fix surface-mounted devices (SMDs) components were investigated and optimized. The ECA was used to transfer SMD resistors onto paper with printed zinc contact pads. The stability of the paste was assessed for 1 month at room temperature with less than 1% change in resistance. Mechanical bending of SMDs bonded onto the substrate was evaluated. The paste was also implemented to fabricate a zinc paper-based RFID card.