The increasing penetration of renewable energy sources (RESs) in transmission and distribution systems presents several challenges for grid operators. In particular, the unpredictable behavior of RESs can disrupt the balance between energy production and load demand, potentially affecting the stability of the entire system. Grid-connected energy storage systems (ESSs) offer a possible solution to manage the uncertainty associated with RESs. In fact, ESSs exchange power with the grid through the adoption of suitable energy management strategies, which are typically implemented by power electronics-based grid interfaces. Unlike other current source converter (CSC) solutions described in the literature, which only interface with a single energy storage device, this paper introduces a novel topology for a three-phase delta-type current source converter (D-CSC), which is capable of integrating three independent ESSs using the same number of semiconductors as traditional CSC solutions. Thus, it considerably enhances the flexibility of a power conversion system (PCS) without increasing the number of converter components. In addition, an innovative energy management control strategy is also introduced. This strategy enables the D-CSC to compensate for energy imbalances arising between the three ESSs, which might be caused by several factors, such as different aging characteristics, converter component tolerances, operating conditions, and temperature drifts. Hence, the D-CSC-based interface is capable of proper grid operation even if the three ESSs have different characteristics, thus opening the possibility of employing this converter to integrate both first and second-life devices. First, the topology of the proposed D-CSC is introduced, followed by a detailed mathematical description of its control strategy. The proper grid operation of the D-CSC was tested under different scenarios, considering the grid integration of three independent superconducting magnetic energy storage systems in a marine vessel. The proposed D-CSC is compared to traditional CSC solutions, highlighting the superior performances of the novel converter topology in terms of efficiency, total harmonic distortion of the output currents, and overall cost reduction for the PCS.

Recently, modular multilevel converters (MMCs) gained popularity for the grid integration of photovoltaic (PV), due to their many advantages, including low total harmonic distortion, high control flexibility, and distributed maximum power point (MPP) tracking capability. Two distinguished families of MMCs exist: voltage source and current source. Voltage source MMCs are mostly studied, but current source MMCs offer advantages under certain operating conditions. This article compares voltage and current source MMCs, for PV integration. To this aim, several key indicators are identified: number of components, energy stored in passive elements, semiconductor power rating, and the number of MPP trackers. The results of the analysis, performed in MATLAB©, show that for a fixed number of output voltage levels, power rating, and switching frequency, voltage source MMCs have simpler control and higher number of MPP trackers. In contrast, current source MMCs minimize the semiconductor power rating, the number of components and the energy stored in passive elements. Regarding efficiency, in the analyzed case study, voltage source MMCs perform better under both homogeneous and non‐homogenous irradiance conditions. This article provides a tool to select the optimal solution based on the required target (e.g. efficiency, energy storage etc.), given the specific characteristics of the application.

In recent years, significant resources have been invested by both the research community and industry in the study and development of isolated dc/dc converters for interfacing renewable energy sources and storage systems. In this context, the electrical isolation between different stages of the system is a mandatory requirement for several applications. This study investigated a novel isolated dc/dc current source converter with capacitive isolation. The proposed solution consists of two bridges, each one realized using four reverse-blocking switches, interfaced through two isolation capacitors, and a shunt high frequency capacitor allowing power to be transferred between the two dc sides. The converter structure, operating principles, and component sizing requirements were first analyzed. Then, simulations were performed using MATLAB/Simulink© and LTSpice© to demonstrate the operation of a 10 kW converter, which confirmed the results of a theoretical analysis. Experimental tests were also conducted on a scaled prototype.