Epoxidised soybean oil (ESO) was cross-linked with an aqueous citric acid (CA) solution without the addition of any other catalyst or solvent. Completely bio-based polymer networks were generated. The initial system was an emulsion, but it became a homogeneous and transparent polymer network by reaction. The ability of the final materials to self-heal without adding extrinsic catalysts was assessed by stress relaxation and lap-shear tests. This was achieved by molecular rearrangements produced by thermally activated transesterification reactions of β-hydroxyester groups generated in the polymerization reaction.
Thermosetting polymers were synthesized from a commercial epoxy resin (diglycidyl ether of bisphenol A, DGEBA) and tricarboxylic (citric, CA) and different dicarboxylic (sebacic, SA and glutaric, GA) acids. Crosslinking of DGEBA–SA and DGEBA–GA systems was achieved using excess epoxy, which was homopolymerized after all the acid groups were consumed. It was found that the properties of the material depend on the diacid length and on the excess epoxy, and with the proper formulation, vitrimers with Tg values ranging from 51 °C to 62 °C, and a high rate of stress relaxation (less than 1 h at 160 °C to achieve 63% of relaxation) could be obtained. Notably, using a mixture of tri-functional CA with SA allowed a reduction in the epoxy excess while maintaining a high Tg value and faster stress relaxation. Three of the formulations were selected and their shape memory performance was studied. Good shape fixity and shape recovery ratios (>99%) were obtained, which indicate an overall good shape memory performance. These properties can be used to create different permanent and temporary shapes on a thermosetting polymer obtained from widely available and affordable raw materials.
Vitrimers are covalently crosslinked polymers that behave as conventional thermosets below the glass transition temperature (Tg) but can flow above a particular temperature, Tv > Tg, by bond exchange reactions. In epoxy vitrimers, transesterification reactions are responsible for their behavior at T > Tv that enables flow, thermoforming, recycling, self-healing and stress relaxation. A statistical analysis based on the fragment approach was performed to analyze the evolution of the network structure of epoxy vitrimers during transesterification reactions. An analytical solution was obtained for a formulation based on a diepoxide and a dicarboxylic acid. A numerical solution was derived for the reaction of a diepoxide with a tricarboxylic acid, as an example of the way to apply the model to polyfunctional monomers. As transesterification acts as a disproportionation reaction that converts two linear fragments (monoesters) into a terminal fragment (glycol) and a branching fragment (diester), its effect on network structure is to increase the concentration of crosslinks and pendant chains while leaving a sol fraction. Changes in the network structure of the epoxy vitrimer can take place after their synthesis, during their use at high temperatures, a fact that has to be considered in their technological applications.
5 June 2015 in ACS Sustainable Chemistry & Engineering