The process for the production of biodiesel can be intensified significantly by employing heterogeneous catalysts that can tolerate free fatty acid in the feedstock. The synthesis of biodiesel was experimentally investigated in a fixed bed reactor using refined sunflower oil (triglyceride) and raw Jatropha oil (triglyceride with free fatty acid). A zinc-based catalyst was used in the form of cylindrical pellets of 6 mm in diameter and 8–10 mm in length. For the raw Jatropha oil, conversions greater than 90% were realized for both triglycerides and free fatty acids (FFAs), typically at 200 °C and a molar ratio of 6 : 1 (methanol : oil) for a residence time of 40 gcat ml−1 min. The experimental results for the refined oil in the fixed bed reactor (FBR) are explained using an appropriate model that incorporates both simplified kinetics and external mass transfer resistances at liquid–liquid and solid–liquid interfaces. The comparison of FBR results with those of the independent experiments in a spinning basket reactor, in the absence of external mass transfer limitations, shows that the intrinsic reaction is very fast. Hence, in the fixed bed reactor, mass transfer limitations especially at the liquid–liquid interface play an important role under the conditions employed. The rates in the case of refined sunflower oil are significantly lower compared to those of Jatropha oil, due to the presence of FFA, mono- and diglycerides in the latter.
3 November 2024 in Journal of Material Cycles and Waste Management
Transesterification of triglycerides (TGs) is associated with the coexistence of two sparingly miscible liquid phases. In this study, the reaction is carried out in a batch reactor with independent stirring of both the phases by maintaining a flat interface. An initial delay period followed by a sudden rise in reaction rate is observed. The S-shaped TG conversion curve thus represents an in situ change in the rate-controlling step during the course of reaction. The intrinsic reaction is reasonably fast and the progress of the reaction, in the initial period, is strongly influenced by the speed of agitation and the interfacial area. A spontaneous emulsion is observed as the reaction proceeds, resulting in a sudden rise in the interfacial area, and hence, the reaction rate. We observed that the change in the compositions of the individual phases was responsible for a decrease in the interfacial tension. At a particular concentration of the individual phases, a spontaneous emulsion is realized, beyond which, the reaction becomes kinetically controlled. During this period, the reaction rate is independent of agitation speed. The experimental results in both the pre- and post-emulsion period are explained using an appropriate model. We demonstrate that an appropriate selection of the initial composition of the two phases in a conventional batch reactor can conveniently eliminate the initial delay due to diffusional limitations.