This study aimed to compare the nanoleakage of retrograde fillings with premixed calcium silicate-based putty and mineral trioxide aggregate (MTA), using two different techniques (traditional and Lid). Sixty-four extracted human teeth were decoronated, then root canals and ends were instrumented for retrograde filling and divided into four groups according to the retrograde filling technique: the traditional and the Lid technique. Each group (n = 15) was filled with Ceraseal + Well-Root putty, Well-Root putty, Ceraseal + ProRoot MTA, and ProRoot MTA. The nanoleakage was evaluated using the Nanoflow device (IB Systems) on days 1, 3, 7, 15 and 30. Data were collected twice per second at the nanoscale (nL/s) and calculated after archiving the stabilization of fluid flow. The Kruskal–Wallis and Mann–Whitney U-tests were used for statistical analysis. All groups showed enhanced sealing ability over time. Regardless of filling materials, the Well-Root putty, Ceraseal+Well-Root putty, and Ceraseal+ProRoot MTA groups indicated less nanoleakage than the ProRoot MTA group in the first week of evaluation (p < 0.05). Although all groups did not show significant differences after 2 weeks, the Ceraseal+ProRoot MTA group leaked less than ProRoot MTA on Days 3 and 7 (p < 0.05). The scanning electron microscopic examined good adaptation to the cavity wall, which was similar to nanoleakage results. Premixed calcium silicate-based putty retrograde filling material alone and using the “lid technique” were shown to be faster and less prone to nanoleakage when compared to MTA.
31 December 2020 in Journal of Korean Dental Association
Objectives: The primer (G-Cem One Adhesive Enhancing Primer), which promote self-polymerization more in the absence of polymerization light is developed. To date, many studies on the mechanical properties and prognosis of various self-adhesive resin cements have been published. Since there is almost no comparison of the degree of polymerization depending on the application of primers, this study was attempted. Materials and Methods: A total of three types of dual cure self-adhesive resin cements (G-Cem One, G-Cem LinkAce, Rely-X U200) and one type of dual cure resin cement (Rely-X Ultimate) were evaluated. G-Cem One Primer was used as a primer enhancing of auto-polymerization. A mold 5 mm in diameter and 2 mm thick was made from aluminum, primers were applied on a glass slit, and each material was filled in the mold, and self-polymerization was induced. The microhardness was measured with a Vickers microhardness machine after 10 minutes, 1 hour,3 hours,6 hours and 24 hours. All dates were statistically analyzed. Results: G-Cem One, G-Cem LinkAce and Rely-X U200 showed high microhardness values when primers were applied at the beginning of cement mixing. Primer application did not show significantly different in Rely-X Ultimate. Conclusion: The application of a new primer has a dual cure self-adhesive resin cement which promotes the polymerization at the beginning of the mixing.
30 June 2020 in Journal of Dental Rehabilitation and Applied Science