The swing of the riser in deep-water drilling can significantly impact the drill string. In this study, we establish a riser model that considers the combined disturbance of periodic dynamic wind and wave loads. By coupling it with the drill string model, we develop a dynamic model for deep-water drilling systems. Through analyzing multiple sets of different drilling parameters, we examine displacements and impact forces at various positions along the drill string system. Specifically, our focus lies on velocity, acceleration, and rotational speed information of BHA. We investigate how WOB and rotational speed influence motion trajectory and vibration characteristics of the drill string within the dynamic model of deep-water drilling systems. Simulation results reveal slight differences in whirling trajectories between inside the riser and below mud line for the drill string. Rotational speed has a greater impact on the drill string compared to WOB; higher rotational speeds lead to increased collision forces between the drill string system and both riser and wellbore. Our findings identify specific combinations of WOB and rotational speed parameters that can stabilize drilling operations within dynamic models for deep-water drilling systems. These research results provide valuable insights for adjusting WOB and rotational speed parameters in deep-water drilling.
In drilling engineering, the cost of drilling tool fracture is enormous, and studying the fatigue failure process of drilling tools has practical significance. This paper uses metal magnetic memory detection technology to design and conduct fatigue damage tests on typical drilling tool material 42CrMo specimens under tensile, torsional, compressive, tensile, compressive, and torsional dynamic loading conditions. By analyzing the changes in the tangential component Hp(x) and gradient value K of the magnetic memory signal under different load conditions with the number of loading times, the process of fatigue failure of the specimens and the trend of changes in the magnetic memory signal in local stress concentration areas are explored. The characteristic parameters of fatigue damage based on magnetic memory detection were extracted and the critical point at which fatigue damage leads to crack initiation was inferred. This confirms that metal magnetic memory testing technology is an effective means of analyzing the fatigue damage process of drilling tools and provides a certain reference for formulating judgment standards for drilling tool maintenance on site.
The evaluation of rock properties is an indispensable part of the process of developing deep oil and gas resources. Traditional lithology identification methods have limitations such as high cost and time consumption. During the drilling operation, the interaction between the drill bit and the formation occurs, and the dynamic vibration response of the drill bit can represent the geological characteristics of the formation. In this paper, the differences in vibration response during the drilling process are explored by experimental methods, and the feasibility of using vibration signals to judge the change in rock stratum is investigated. A full-scale drill bit rock breaking test rig is constructed, and laboratory experiments on full-size Polycrystalline Diamond Compact (PDC) bit rock breaking are carried out, during which vibration response data under different drilling parameters are collected. The differences among experimental datasets are then analyzed and compared, and key data characteristics are extracted. Based on these, a new method for discriminating formation lithology is proposed. The results show that the amplitude of vibration response is closely related to drilling parameters and rock properties. The frequency composition of the vibration is only affected by the properties of the rock strata and is not affected by drilling parameters. Furthermore, the model established based on differences in vibration responses can effectively identify lithological changes, with an identification accuracy rate exceeding 95%. This study offers a theoretical basis for identifying lithologic changes in field production and serves as a valuable supplement to existing methods.