Surface soil moisture (SSM) plays significant roles in various scientific fields, including agriculture, hydrology, meteorology, and ecology. However, the spatial resolutions of microwave SSM products are too coarse for regional applications. Most current optical/thermal infrared SSM retrieval models cannot directly estimate the quantitative volumetric soil water content without establishing empirical relationships between ground-based SSM measurements and satellite-derived proxies of SSM. Therefore, in this paper, SSM is estimated directly from 5-km-resolution Chinese Geostationary Meteorological Satellite FY-2E data based on an elliptical-new SSM retrieval model developed from the synergistic use of diurnal cycles of land surface temperature (LST) and net surface shortwave radiation (NSSR). The elliptical-original model was constructed for bare soil and did not consider the impacts of different fractional vegetation cover (FVC) conditions. To optimize the elliptical-original model for regional-scale SSM estimates, it is improved in this paper by considering the influence of FVC, which is based on a dimidiate pixel model and a Moderate Resolution Imaging Spectroradiometer normalized difference vegetation index product. A preliminary validation of the model is conducted based on ground measurements from the counties of Maqu, Luqu, and Ruoergai in the source area of the Yellow River. A correlation coefficient (R) of 0.620, a root-mean-square error (RMSE) of 0.146 m³/m³, and a bias of 0.038 m³/m³ were obtained when comparing the in situ measurements with the FY-2E-derived SSM using the elliptical-original model. In contrast, the FY-2E-derived SSM using the elliptical-new model exhibited greater consistency with the ground measurements, as evidenced by an R of 0.845, an RMSE of 0.064 m³/m³, and a bias of 0.017 m³/m³. To provide accurate SSM estimates, high-accuracy FVC, LST, and NSSR data are required. To complement the point-scale validation conducted here, cross-comparisons with other existing SSM products will be conducted in the future studies.
Based on a novel bare surface soil moisture (SSM) retrieval model developed from the synergistic use of the diurnal cycles of land surface temperature (LST) and net surface shortwave radiation (NSSR) (Leng et al. 2014. “Bare Surface Soil Moisture Retrieval from the Synergistic Use of Optical and Thermal Infrared Data”. International Journal of Remote Sensing 35: 988–1003.), this paper mainly investigated the model’s capability to estimate SSM using geostationary satellite observations over vegetated area. Results from the simulated data primarily indicated that the previous bare SSM retrieval model is capable of estimating SSM in the low vegetation cover condition with fractional vegetation cover (FVC) ranging from 0 to 0.3. In total, the simulated data from the Common Land Model (CoLM) on 151 cloud-free days at three FLUXNET sites that with different climate patterns were used to describe SSM estimates with different underlying surfaces. The results showed a strong correlation between the estimated SSM and the simulated values, with a mean Root Mean Square Error (RMSE) of 0.028 m3·m−3 and a coefficient of determination (R2) of 0.869. Moreover, diurnal cycles of LST and NSSR derived from the Meteosat Second Generation (MSG) satellite data on 59 cloud-free days were utilized to estimate SSM in the REMEDHUS soil moisture network (Spain). In particular, determination of the model coefficients synchronously using satellite observations and SSM measurements was explored in detail in the cases where meteorological data were not available. A preliminary validation was implemented to verify the MSG pixel average SSM in the REMEDHUS area with the average SSM calculated from the site measurements. The results revealed a significant R2of 0.595 and an RMSE of 0.021 m3·m−3.
11 April 2017 in IEEE Journal of Selected Topics in Applied Earth Observations and Remote Sensing
Land surface temperature (LST) is a key variable used for studies of water cycles and energy budgets of land-atmosphere interfaces. This study addresses the theory of LST retrieval from data acquired by the Chinese operational geostationary meteorological satellite FengYun-2E (FY-2E) in two thermal infrared channels (IR1: 10.29-11.45 μm and IR2: 11.59-12.79 μm) using a generalized split-window algorithm. Specifically, land surface emissivity (LSE) in the two thermal infrared channels is estimated from the LSE in channels 31 and 32 of the moderate-resolution imaging spectroradiometer (MODIS) product. In addition, an eight-day composition MODIS LSE product (MOD11A2) and the daily MODIS LSE product (MOD11A1) are used in the algorithm to estimate FY-2E emissivities. The results indicate that the LST derived from MOD11A1 is more accurate and, therefore, more appropriate for daily cloud-free LST estimation. Finally, the estimated LST was validated using the MODIS LST product for the heterogeneous source area of the Yellow River. The results show a significant correlation between the two datasets, with a correlation coefficient (R) varying from 0.60 to 0.94 and a root mean square error ranging from 1.89 to 3.71 K. Moreover, the estimated LST agrees well with ground-measured soil temperatures, with an R of 0.98.
7 February 2025 in IEEE Transactions on Geoscience and Remote Sensing
Sea surface temperature (SST) is a vital parameter in oceanography and climate science, influencing various fields. While remote sensing provides daily SST data, thermal infrared (TIR)-based sensors offer higher spatial resolution but struggle with cloud penetration, often resulting in data gaps and inaccuracies. This study proposes an SST reconstruction framework based on a diffusion model that integrates spatiotemporal information using Himawari TIR and OSTIA SST data, yielding a fully covered SST dataset with a spatial resolution of 0.02°. The model demonstrates good performance in reconstructing SST in the South China Sea (SCS), achieving a coefficient of determination (R²) of 0.92, a bias of 0.06 °C, an root mean square error (RMSE) of 0.39 °C, and a peak signal-to-noise ratio (PSNR) of 57.93. Furthermore, the transferability of the model is confirmed through accurate SST predictions in the Indian Ocean after training on SCS data, indicating its applicability across different regions with limited Himawari data and its potential for broader geographical applications. Compared to the original Himawari data, the reconstructed SST reduces the RMSE from 1.01 °C to 0.29 °C, increases the R² from 0.71 to 0.86, and adjusts the bias from –0.54 °C to 0.02 °C, thereby enhancing accuracy. By integrating temporal information, the proposed approach captures both spatial and temporal characteristics of SST, effectively representing seasonal variations, small-scale pulsations, rapid coastal changes, and stable offshore fluctuations. This study lays the groundwork for applying the proposed framework to other regions, highlighting its potential for broader applications in generating high-resolution, all-weather SST data.
12 March 2021 in IEEE Geoscience and Remote Sensing Letters
Due to the coarse spatial resolution of currently available microwave (mostly passive) soil moisture (SM) products, it is difficult to apply these SM data in watersheds or at local scales. To this end, a number of downscaling approaches have been developed to improve the spatial resolution of microwave SM products. Specifically, the optical-/thermal-based downscaling methods are most widely used in recent decades. However, such methods normally rely on instantaneous optical/thermal land surface parameters, which are commonly inapplicable under cloudy conditions. The purpose of this study is to develop a new downscaling method based on the temporal variation in geostationary satellite-derived land surface temperature and net surface shortwave radiation. The proposed method has a certain potential to improve data availability under cloudy conditions, because geostationary satellites are capable of providing land surface parameters at high temporal resolution. The proposed method was tested over the REMEDHUS network in Spain. The scaling strategy of cumulative distribution function matching was used to remove systematic differences in spatial mismatch between satellite pixels and in situ SM measurements. Results indicate that the downscaled SM agrees well with in situ measurements and has comparable accuracy with the original microwave SM product. The overall root mean square errors with the in situ measurements for the original microwave SM and the downscaled SM are 0.054 and 0.057 $\text{m}^{3}/\text{m}^{3}$ , respectively. This method not only has a successful attempt to downscale microwave SM data using temporal information but also has the potential to avoid the failure of traditional instantaneous observations-based downscaling procedure due to clouds.