An Oxygen Diffusion Layer (ODL) was generated on the surface of Ti6Al4V alloy by thermal oxidation treatment. In vitro tests for cytotoxicity were performed in the presence of Ti6Al4V and the ODL samples with the culture of G292 Cells using MTT assay. The results showed a similar cell viability in the presence of the both samples. Wear behaviour of Ti6Al4V and the ODL samples was investigated in a phosphate buffered saline solution under a normal load of 30N at a sliding velocity of 0.1m/s. The worn surface and subsurface of the samples were studied using SEM, STEM, TEM, XPS, AFM, nano-hardness and surface profilometry. A bio-tribofilm was observed on the worn surface of the ODL. TEM studies showed that the tribofilm had an amorphous structure and contained oxygen and phosphorous as confirmed by XPS and EDS analysis. AFM images also revealed that the tribofilm consisted of compacted fine debris. The formation of the tribofilm on the ODL with higher hardness and strength resulted in a decrease of about 95% in the wear rate compared with Ti6Al4V alloy.
24 February 2015 in Journal of Bio- and Tribo-Corrosion
This study was undertaken to investigate the effect of heat treatments on the high-temperature wear behavior of 60Nitinol. The samples were hot-worked, aged at two temperatures of 400 and 700°C for 1 h and then water quenched. The microstructure of the alloys was investigated by scanning electron microscopy and X-ray diffraction. Sliding wear tests were performed at two temperatures of 25 and 200°C using three types of 60Nitinol disks: hot-worked, aged at 400°C, and aged at 700°C. All wear tests were performed at a speed of 0.3 m/s under a normal load of 60 N for a total sliding distance of 1,000 m using WC-Co pins sliding against 60Nitinol disks. The worn surfaces and microstructure of the subsurfaces were studied by scanning electron microscopy. Compression and hardness tests were also performed to characterize the mechanical properties of the alloys. The highest fracture strain and lowest hardness were obtained for the sample aged at 700°C that contained Ni3Ti2 precipitants. This sample also showed the maximum wear resistance at a wear testing temperature of 200°C. This was attributed to the formation of a more compact and stable tribological layer on the worn surface of the softer sample.
A slurry impingement rig containing 6 wt.% SiO2 particles was used to investigate synergistic erosion–corrosion behavior of X-65 carbon steel at various impingement angles. Maximum erosion–corrosion and erosion rates occurred at impingement angles of about 25 deg and 40–55 deg, respectively. The synergy value highly depended on the impingement angle. The formation of patches of porous corrosion product followed by the formation of corrosion pits led to a positive synergy under impingement angle of 25 deg. At higher impingement angles, the absence of pits probably due to the formation of a more durable tribocorrosion layer resulted in a negative synergy.