The end-of-life management of plastic represents a significant environmental challenge, largely due to its limited use, low biodegradability, and high volume of disposed material, in the order of 400 million tonnes by 2019. Several types of polymers can be recycled by mechanical means, but some others, like plastics, sometimes require chemical methods for their reuse. In this context, gasification is one of the most promising chemical recycling techniques. Gasification is a thermochemical process performed at moderate temperatures of work (800–1100 °C) that converts carbonaceous materials into rich hydrogen gas, which can be used for energy obtention or the Fisher–Tropsch process. However, this procedure can also produce undesirable by-products like tar and char. The products’ composition and relative quantities are highly dependent on the overall process configuration and the input fuel. The current study evaluates the catalytic gasification of the most common plastic waste, seeking to obtain higher gas yields and syngas with high energy. The text focuses on the current state of development and recent advances in various publications over the last fifteen years, with emphasis on thermoplastics and thermosets. The search showed that temperatures, the type of fluidizing gas, and the catalyst have a major influence on the quality of the obtained gas. Optimal gasification conditions, such as temperatures between 600 and 900 °C, depending on the plastic feedstock, steam-to-feedstock ratios > 1, the appropriate selection of a gasifying agent according to gas requirements and energy optimization, and the composition and location of the catalyst in the system (in situ, in the reactor, or ex situ), are identified as critical for maximizing H₂ and CO production and minimizing tar. Finally, we provide summaries of the last advanced patent in the field, where the main focus appears to be feedstock pretreatment intended to ensure handling feasibility due to the variety of plastic wastes.

The possibility of regenerating the solvent of extraction units by cyclic adsorption was analyzed. This combination seems convenient when extraction is performed with a high solvent-to-impurity ratio, making other choices of solvent regeneration, typically distillation, unattractive. To our knowledge, the proposed regeneration scheme has not been considered before in the open literature. Basic relations were developed for continuous and discontinuous extraction/adsorption combinations. One example, deacidification of plant oil with alcohol, was studied in detail using separate experiments for measuring process parameters and simulation for predicting performance at different conditions. An activated carbon adsorbent was regenerated by thermal swing, making cyclic operation possible. When extracting the acid with methanol in a spray column, feed = 4 L min⁻¹, solvent = 80 L min⁻¹, feed impurity level 140 mmol L⁻¹, and extract concentration 7.6 mmol L⁻¹, the raffinate reaches a purity of 1.2 mmol L⁻¹, the solvent being regenerated cyclically in the adsorber (364 kg) to an average of 0.7 mmol L⁻¹. Regeneration of the solvent by cyclic adsorption had a low heat duty. Values of 174 kJ per litre of solvent compared well with the high values for vaporization of the whole extract phase (1011 kJ L⁻¹).