In this work, the dielectric loss tangent ($\tan \hspace{0.17em}\delta$ ) of a series of strain sensors, fabricated from an epoxy nanocomposite with multi-wall carbon nanotube (MWCNT) content varying at 1 wt. % – 5 wt. %, was characterized experimentally. The effects of four parameters including frequency, strain of nanocomposite, MWCNT content, and loading voltage were investigated extensively. Moreover, an alternative current gauge factor K_AC was developed. The largest value of K_AC was found to be 256 for the nanocomposite strain sensor with 1 wt. % MWCNT content at 0.6% tensile strain, which indicates the ultra-sensitivity of the present strain sensor.

Expansion due to compression (EDC) test has been applied to evaluate the performance of nuclear fuel claddings where pellet-cladding mechanical interaction (PCMI) is introduced by swelling of fuel pellets and is triggered by the larger hoop deformation of the pellets, especially during accidental transients. The purpose of this study is to modify the EDC test to describe PCMI, specimen volume reduction and others. Ring-shaped specimens were cut from Zry-4 cladding tubes. Cylindrical metal pellets with 8 mm in diameter and 15 mm in maximum height were used as inner pellets. Expansion of the specimens due to the inner pellet compression was performed at room temperature. The experimental data were further analyzed by finite element method. Through the survey in the variation of the specimen and core, specimen size and inner pellet geometry were optimized. Excellent reproducibility with less error was confirmed. The uniaxial tension condition in the hoop direction up to the specimen failure was confirmed. Hoop stress–hoop strain curves were successfully derived.

Lead-cooled fast reactors exhibit strong inherent safety performance and good economic features, while material degradation due to corrosion and irradiation is still challenging. Oxide dispersion-strengthened steels are one of the promising candidates for fuel cladding materials. The effects of both irradiation and corrosion on ODS steel need to be further studied. In this work, MX-ODS steel was irradiated by Fe ions at 500 °C up to 46 dpa. Later, the as-received specimen and the irradiated specimen were used to conduct corrosion tests in oxygen-saturated Pb at 550 °C for 1 h. In the as-received specimen, discontinuous oxides penetrated by Pb and Pb in contact with steel matrix were observed, demonstrating unsatisfactory corrosion resistance of the material. However, in the irradiated specimen after corrosion experiment, a protective oxide layer formed and prevented Pb attack. The oxidation behavior differences between the two specimens can be attributed to the defects produced by irradiation and the structural discrepancy in oxides caused by the formation process. A possible mechanism of irradiation on the corrosion is discussed. In the as-received specimen, Fe atoms loss led to voids in the oxides, and lead penetrated the oxides through these voids. In the irradiated specimen, defects left by previous irradiation helped to form a more uniform oxide layer. The adhesive outer magnetite oxide and the Fe ions generated from where grain boundary oxidation developed retarded the presence of voids and made the oxide layer protective.