Jiannong Quan

Dr. Jiannong Quan


Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
17 April 2018 in Scientific Reports
Verified
Journal Article
Open access
PDF file
QLQuan Liu
Quan Liu
XJXingcan Jia
Xingcan Jia
JQJiannong Quan
Jiannong Quan
JLJiayun Li
Jiayun Li
XLXia Li
Xia Li
YLYangang Liu
Yangang Liu
Severe haze events during which particulate matter (PM) increases quickly from tens to hundreds of microgram per cubic meter in 1–2 days frequently occur in China. Although it has been known that PM is influenced by complex interplays among emissions, meteorology, and physical and chemical processes, specific mechanisms remain elusive. Here, a new positive feedback mechanism between planetary boundary layer (PBL), relative humidity (RH), and secondary PM (SPM) formation is proposed based on a comprehensive field experiment and model simulation. The decreased PBL associated with increased PM increases RH by weakening the vertical transport of water vapor; the increased RH in turn enhances the SPM formation through heterogeneous aqueous reactions, which further enhances PM, weakens solar radiation, and decreases PBL height. This positive feedback, together with the PM-Radiation-PBL feedback, constitutes a key mechanism that links PM, radiation, PBL properties (e.g. PBL height and RH), and SPM formation, This mechanism is self-amplifying, leading to faster PM production, accumulation, and more severe haze pollution.

5 January 2019 in Journal of Geophysical Research: Atmospheres
Verified
Journal Article
Open access
PDF file
XJXingcan Jia
Xingcan Jia
JQJiannong Quan
Jiannong Quan
ZZZiyan Zheng
Ziyan Zheng
XLXiange Liu
Xiange Liu
QLQuan Liu
Quan Liu
YLYangang Liu
Yangang Liu
Fog poses a severe environmental problem in the North China Plain, China, which has been witnessing increases in anthropogenic emission since the early 1980s. This work first uses the WRF/Chem model coupled with the local anthropogenic emissions to simulate and evaluate a severe fog event occurring in North China Plain. Comparison of the simulations against observations shows that WRF/Chem well reproduces the general features of temporal evolution of PM2.5 mass concentration, fog spatial distribution, visibility, and vertical profiles of temperature, water vapor content, and relative humidity in the planetary boundary layer throughout the whole period of the fog event. Sensitivity studies are then performed with five different levels of anthropogenic emission as model inputs to systematically examine the comprehensive impacts of aerosols on fog microphysical, macrophysical, radiative, and dynamical properties. The results show that as aerosol concentration increases, fog droplet number concentration and liquid water content all increase nonlinearly; but effective radius decreases. Macrophysical properties (fog fraction, fog duration, fog height, and liquid water path) also increase nonlinearly with increasing aerosol concentration, with rates of changes smaller than microphysical properties. Further analysis reveals distinct aerosol effects on thermodynamic and dynamical conditions during different stages of fog evolution: increasing aerosols invigorate fog formation and development by enhancing longwave‐induced instability, fog droplet condensation accompanying latent heat release, and thus turbulence, but delay fog dissipation by reducing surface solar radiation, surface sensible, and latent heat fluxes, and thus suppressing turbulence during the dissipation stage.

8 February 2021 in Journal of Geophysical Research: Atmospheres
Verified
Journal Article
Open access
PDF file
ZLZhiheng Liao
Zhiheng Liao
Zhenhao LingZhenhao Ling
Zhenhao Ling
MGMeng Gao
Meng Gao
JSJiaren Sun
Jiaren Sun
WZWei Zhao
Wei Zhao
SFShaojia Fan
Shaojia Fan
The recent 20 years (2000–2019) ozonesonde profiles recorded at the Hong Kong Observatory are analyzed to study the Tropospheric Ozone (TropO3) variability over Hong Kong, South China. The TropO3 profiles are described without the constraints of traditional monthly averages; they are clustered based on a Self‐Organizing Map (SOM) to explore the short‐term variability, and separated into two 10‐year periods to investigate the long‐term variability based on pooled statistical analysis. The roles of precursor emissions, dynamic transport, and photochemical formation in multiple‐timescale TropO3 variability are further evaluated with the aid of meteorological and satellite data, surface observation, emission inventory, and backward trajectory analysis. The results suggest that TropO3 over Hong Kong has a seasonal and vertical distribution featuring a widely recognized spring maximum. The SOM‐based clustering analysis emphasizes a strong dependence of short‐term variability in TropO3 profile patterns on cross‐latitude transport conditions, including rich‐O3 transport from midlatitude region and poor‐O3 transport from tropics. However, high O3 levels throughout the troposphere (usually in early spring) are largely due to the combination of stratospheric intrusion and biomass burning. During the whole study period, the O3 concentrations have increased substantially in the lower troposphere. Springtime wildfire‐related emissions over the upwind Indochina Peninsula are responsible for the lower free‐tropospheric O3 increases. In contrast, the boundary‐layer O3 uptrends with a larger increasing rate near the surface are mostly attributed to the reduced NO titration effect due to the sharp reduction of NOx emissions.

21 April 2020 in Atmospheric Chemistry and Physics
Verified
Journal Article
Open access
PDF file
DZDandan Zhao
Dandan Zhao
GLGuangjing Liu
Guangjing Liu
Jinyuan XinJinyuan Xin
Jinyuan Xin
JQJiannong Quan
Jiannong Quan
YWYuesi Wang
Yuesi Wang
FWFangkun Wu
Fangkun Wu
Under a high atmospheric oxidization capacity, the synergistic effect of the physicochemical processes in the atmospheric boundary layer (ABL) caused summer haze pollution in Beijing. The southern and southwestern areas, generally 60–300 km away from Beijing, were seriously polluted in contrast to Beijing, which remained clean. Southerly winds moving faster than 20–30 km h−1 since the early morning primarily caused haze pollution initiation. The PM2.5 (particulate matter with a dynamic equivalent diameter smaller than 2.5 µm) level increased to 75 µg m−3 over several hours during the daytime, which was simultaneously affected by the ABL structure. Additionally, the O3 concentration was quite high during the daytime (250 µg m−3), corresponding to a high atmospheric oxidation capacity. Much sulfate and nitrate were produced through active atmospheric chemical processes, with sulfur oxidation ratios (SORs) up to ∼0.76 and nitrogen oxidation ratios (NORs) increasing from 0.09 to 0.26, which further facilitated particulate matter (PM) level enhancement. However, the increase in sulfate was mainly linked to southerly transport. At midnight, the PM2.5 concentration sharply increased from 75 to 150 µg m−3 over 4 h and remained at its highest level until the next morning. Under an extremely stable ABL structure, secondary aerosol formation dominated by nitrate was quite intense, driving the haze pollution outbreak. The PM levels in the southern and southeastern areas of Beijing were significantly lower than those in Beijing at this time, even below air quality standards; thus, the contribution of pollution transport had almost disappeared. With the formation of a nocturnal stable boundary layer (NSBL) at an altitude ranging from 0–0.3 km, the extremely low turbulence kinetic energy (TKE) ranging from 0 to 0.05 m2 s−2 inhibited the spread of particles and moisture, ultimately resulting in elevated near-surface PM2.5 and relative humidity (∼90 %) levels. Due to the very high humidity and ambient oxidization capacity, NOR rapidly increased from 0.26 to 0.60, and heterogeneous hydrolysis reactions at the moist particle surface were very notable. The nitrate concentration steeply increased from 11.6 to 57.8 µg m−3, while the sulfate and organics concentrations slightly increased by 6.1 and 3.1 µg m−3, respectively. With clean and strong winds passing through Beijing, the stable ABL dissipated with the potential temperature gradient becoming negative and the ABL height (ABLH) increasing to ∼2.5 km. The high turbulence activity with a TKE ranging from 3 to 5 m2 s−2 notably promoted pollution diffusion. The self-cleaning capacity of the atmosphere is commonly responsible for air pollution dispersion. However, reducing the atmospheric oxidization capacity, through strengthening collaborative control of nitrogen oxide (NOx) and volatile organic compounds (VOCs), as well as continuously deepening regional joint air pollution control, is urgent.

1 January 2019 in Journal of the Atmospheric Sciences
Verified
Journal Article
Open access
PDF file
QLQuan Liu
Quan Liu
JQJiannong Quan
Jiannong Quan
XJXingcan Jia
Xingcan Jia
Zhaobin SunZhaobin Sun
Zhaobin Sun
XLXia Li
Xia Li
YLYangang Liu
Yangang Liu
Aerosol samples were collected over Beijing, China, during several flights in November 2011. Aerosol composition of nonrefractory submicron particles (NR-PM1) was measured by an Aerodyne compact time-of-flight aerosol mass spectrometer (C-ToF-AMS). This measurement on the aircraft provided vertical distribution of aerosol species over Beijing, including sulfate (SO4), nitrate (NO3), ammonium (NH4), chloride (Chl), and organic aerosols [OA; hydrocarbon-like OA (HOA) and oxygenated OA (OOA)]. The observations showed that aerosol compositions varied drastically with altitude, especially near the top of the planetary boundary layer (PBL). On average, organics (34%) and nitrate (32%) were dominant components in the PBL, followed by ammonium (15%), sulfate (14%), and chloride (4%); in the free troposphere (FT), sulfate (34%) and organics (28%) were dominant components, followed by ammonium (20%), nitrate (19%), and chloride (1%). The dominant OA species was primarily HOA in the PBL but changed to OOA in the FT. For sulfate, nitrate, and ammonium, the sulfate mass fraction increased from the PBL to the FT, nitrate mass fraction decreased, and ammonium remained relatively constant. Analysis of the sulfate-to-nitrate molar ratio further indicated that this ratio was usually less than one in the FT but larger than one in the PBL. Further analysis revealed that the vertical aerosol composition profiles were influenced by complex processes, including PBL structure, regional transportation, emission variation, and the aging process of aerosols and gaseous precursors during vertical diffusion.

16 April 2021 in Atmospheric Chemistry and Physics
Verified
Journal Article
Open access
PDF file
DZDandan Zhao
Dandan Zhao
Jinyuan XinJinyuan Xin
Jinyuan Xin
CGChongshui Gong
Chongshui Gong
JQJiannong Quan
Jiannong Quan
YWYuesi Wang
Yuesi Wang
YMYongjing Ma
Yongjing Ma
Recently, there has been increasing interest in the relation between particulate matter (PM) pollution and atmospheric-boundary-layer (ABL) structure. This study aimed to qualitatively assess the interaction between PM and ABL structure in essence and further quantitatively estimate aerosol radiative forcing (ARF) effects on the ABL structure. Multi-period comparative analysis indicated that the key to determining whether haze outbreak or dissipation occurs is whether the ABL structure satisfies the relevant conditions. However, the ABL structure change was in turn highly related to the PM level and ARF. |SFC−ATM| (SFC and ATM are the ARFs at the surface and interior of the atmospheric column, respectively) is the absolute difference between ground and atmosphere layer ARFs, and the |SFC−ATM| change is linearly related to the PM concentrations. However, the influence of ARF on the boundary layer structure is nonlinear. With increasing |SFC−ATM|, the turbulence kinetic energy (TKE) level exponentially decreased, which was notable in the lower layers or ABL, but disappeared at high altitudes or above the ABL. Moreover, the ARF effects threshold on the ABL structure was determined for the first time, namely once |SFC−ATM| exceeded ∼55 W m−2, the ABL structure tends to quickly stabilize and thereafter change little with increasing ARF. The threshold of the ARF effects on the boundary layer structure could provide useful information for relevant atmospheric-environment improvement measures and policies, such as formulating phased air pollution control objectives.