Cultivated meat edible muscle and fat grown from animal cells is a food whose final quality depends on the biomass produced, its composition, the differentiation extent, and the tissue structure governing texture. As in other cell-based manufacturing, delivering these attributes reproducibly and cost-effectively requires continuous, non-destructive monitoring, with viable cell density, differentiation status, and tissue structure as key readouts. Electrical impedance spectroscopy (EIS) suits this need because it is label-free, automatable, and sensitive to cell density, morphology, and differentiation state. Classical EIS, however, requires electrode contact, complicating sterility and cost in single-use bioreactors. Here, a non-invasive EIS platform based on a modular single-use bioreactor (MSUB) is presented that measures impedance through a thin (~70 µm per layer) plastic barrier, pairing a low-cost disposable fluidic with reusable, non-contact copper plate electrodes. The stack was validated by comparing electrode configurations and confirming negligible temperature dependence between room temperature and 37 °C. Using SV40-immortalized bovine mesenchymal stem cells in suspension across 5–500 kHz, capacitance increased linearly with cell concentration (R² up to 0.93), and pulses caused no detectable viability loss (96% pre- and post-measurement). Aggregation into spheroids lowered apparent capacitance relative to equal-count single-cell suspensions, showing sensitivity to structural organization. On three-dimensional cellulose scaffolds, continuous monitoring tracked proliferation over ~250 h (R² = 0.71). In a single exploratory run, adipogenic induction produced a non-linear capacitance decrease toward a plateau, consistent with direct-contact literature. These results support through-plastic, non-invasive EIS for cultivated meat and identify limitations in cross-run calibration, structural interpretation, and quantitative deployment.