The corrosion of bridging structures affects their stiffness and load-carrying capacity. Hence, predicting the degree of corrosion is critical for their reliability and safety. This study examined the applicability of the newly developed accelerated corrosion test authorised by ISO 16539 Method B for evaluating the corrosion characteristics of the weathering structural steel. The non-coated weathering steel was subjected to 28, 84, and 168 days of accelerated cyclic corrosion test. The same steel material was subjected to atmospheric exposure tests for 6 and 12 months at different locations. The corrosion behaviours of these different tests were compared by the semivariogram analysis. The results indicated that the corroded surfaces of the non-coated weathering steel obtained from the accelerated cyclic corrosion test and atmospheric exposure tests have similar spatial characteristics. The accelerated cyclic corrosion test could simulate the corrosion behaviour of the weathering steel under actual environments.
This paper presents experimental and numerical investigations on the characteristics of residual stresses generated by induction heating (IH) on 12 mm thick steel plates. IH at 250 °C and 350 °C provided high tensile residual stresses in the heating field but high compressive stresses away from the heating field. The double heating case generated higher compressive residual stresses—around 200 MPa—than the single heating case because of the superposition of the compressive residual stresses. It will be expected to improve the fatigue performance of welded joints when IH is applied for repair work on existing steel structural members susceptible to fatigue damage. Numerical simulation models for predicting residual stresses by IH were proposed by adopting the body heat flux input and the surface heat flux input. They will be beneficial for identifying the optimum heating conditions, such as the target temperature and the heating field, for applying IH to the actual repair work of the steel structural members.
A series of experiments and analyses were performed for applying laser-arc hybrid welding to fabricating steel bridge components. Two-pass fully penetrated T-shaped joints using high-performance steel (SBHS400) having a 15-mm thickness were produced using hybrid welding. T-shaped joints having identical dimensions were manufactured using conventional arc welding. Without considering the inter-pass cooling time, the duration of hybrid welding was reduced by roughly 83% in comparison to that for GMAW. The average out-of-plane deformation caused by hybrid welding was decreased by 67% compared to arc welding. The fully coupled thermal elastic–plastic analyses were performed to replicate the distribution of residual stress in as-welded T-shaped joints. The analytical results indicated that the tensile residual stress range in hybrid-welded T-shaped joints was approximately one third (1/3) of that in arc-welded T-shaped joints. The weld joints produced by hybrid welding may have advantages over those produced by arc welding in terms of reducing welding deformation, decreasing welding residual stresses, and shortening welding time when manufacturing large steel bridge components.