In this paper we reported a Surface Acoustic Wave (SAW) resonator as a humidity sensor. Graphene thin film was decorated on the SAW resonator as a humidity sensing layer. Relative humidity was varied (17-80% RH range) and desired humidity content was established in process chamber using controlled water vapours. As humidity level increases, water molecules adsorb onto the graphene surface, causing increases in surface density leads a change in shear acoustic wave properties that can be measured and correlated with the humidity level. A new design of a Colpitts oscillator has been proposed using the SAW device in the feedback network for SAW resonator for operating frequency stability. In order to understand the electrical behaviour of SAW resonator, a modified Butterworth-Van Dyke (mBVD) equivalent circuit model is developed using Advanced Design System (ADS) software. The results show that the motional arm is mainly influenced by the graphene decoration and humidity level exposure. Additionally, it is observed that the static arm remains unaffected by the humidity level and only the motional arm is responsible for water vapour sensing behaviour. The highest sensitivity (S) is 206.27 ppm/%RH, and the limit of detection (LOD) is 0.269% RH. This novel type of humidity sensor stands out for its cost-effectiveness, stability, reliability, and robustness. It proves to be highly beneficial for applications requiring humidity sensing at room temperature.
FeGa and FeGaCr thin films are very promising for magnetic microelectromechanical systems (magMEMS) due to their exceptional magnetic properties. This study investigates MEMS magnetic actuators based on high performance FeGa and FeGaCr thin films. The cantilever deflection was measured using a Laser Doppler Vibrometer (LDV). Furthermore, FeGaCr thin films residual stress was measured and found to be + 143.43MPa which is tensile in nature. X-ray diffraction (XRD) study reveals the cubic phase of FeGaCr films and magnetic properties are corresponding to the cubic phase of thin film. The scanning electron microscope nano-structure results show that the grain size was improved due to the chromium doping effect. Moreover, coercive field (Hc) and saturation magnetization (Ms) both were enhanced by chromium doping. The electrical resistivity of FeGaCr ($8.9364\mu \Omega $ -m) films is lower compared to FeGa ($115.4\mu \Omega $ -m) thin films. The MEMS magnetic actuator was placed in a 1156 Oe magnetic field and shows an in-plane deflection along the cantilever length ($\mathrm{D}_{\mathbf {\parallel }}$ f) of $14.24\mu $ m and a perpendicular deflection ($D_{\perp}$ ) of $10.32~\mu $ m. The chromium doping enhances the magnetic properties. These findings demonstrate that Cr doping effectively alters the structural, magnetic, and electrical properties of FeGa thin films significantly, making them highly suitable for advanced magMEMS applications, including sensors, actuators, vibration control and energy harvesting devices. This study provides valuable insights into the role of dopants in optimizing the performance of magnetostrictive thin films for next-generation magnetic MEMS sensing and transduction technologies.[2025-0091]
1 October 2026 in Journal of Microelectromechanical Systems