We found that nitrogen (N) and silicon (Si) were unintentionally co-doped in Ga2O3 layers grown by plasma-assisted molecular beam epitaxy (PAMBE), and that the ratio between N and Si could be controlled by O/Ga flux ratio during the growth. Note that N and Si act as a deep acceptor (theoretically predicted) and a shallow donor (experimentally confirmed) in Ga2O3, respectively. Taking advantage of this unique characteristic of PAMBE-grown Ga2O3, normally-off operation of Ga2O3 metal-oxide-semiconductor field-effect transistors (MOSFETs) was demonstrated. The unintentionally-doped Ga2O3 channel layer of the MOSFETs had N and Si concentrations of 1×1018 and 2×1017 cm-3, respectively, and thus was considered to behave as a p-type material. The MOSFETs showed a turn-on threshold gate voltage of larger than +8 V, implying formation of an inversion channel in the N-doped Ga2O3 layer. Although the on-state drain current (Id) remained in the subthreshold regime owing to limited gate voltage swing, the Id on/off ratio exceeded five orders of magnitude.
20 October 2016 in Japanese Journal of Applied Physics
Al2O3 films were deposited on β-Ga2O3(010) and β-Ga2O3 substrates by atomic layer deposition at 250 °C, and their interface state densities (Dit) at shallow energies were evaluated using a high–low capacitance–voltage (C–V) method. Al2O3/β-Ga2O3(010) showed lower Dit values (5.9 × 1010 to 9.3 × 1011 cm−2 eV−1) than Al2O3/β-Ga2O3 (2.0 × 1011 to 2.0 × 1012 cm−2 eV−1) in an energy range of −0.8 to −0.1 eV. Cross-sectional transmission electron microscopy analysis indicated the formation of a uniform amorphous Al2O3 layer on the β-Ga2O3 substrate. In contrast, a crystalline Al2O3 interlayer with a thickness of 3.2 ± 0.7 nm with an amorphous Al2O3 top layer was formed on the β-Ga2O3(010) substrate, which effectively decreased Dit. Moreover, thicker interlayers showing lower Dit values at deep state levels were formed at deposition temperatures higher than 100 °C, which were evaluated by shifts in the C–V curves.
β-Ga2O3 metal-oxide-semiconductor field-effect transistors (MOSFETs) with gate lengths (Lg) of 50–1000 nm were fabricated, employing a thin channel layer formed by a shallow Si-ion implantation doping to maintain a high aspect ratio between an Lg and a gate-to-channel distance. The MOSFETs with Lg = 200 nm had a maximum drain current density of about 250 mA/mm and a peak extrinsic transconductance of 17 mS/mm. The short-channel effect was well suppressed for the devices with Lg ≥200 nm, leading to excellent RF device characteristics represented by a record maximum oscillation frequency of 27 GHz at Lg = 200 nm. From simple delay-time analysis on the MOSFETs, the effective electron velocity passing through a region under the gate was estimated to be about 2 × 106 cm/s. Moreover, it was analyzed that the parasitic channel charging delay occupied a substantial proportion of the total delay due to a large sheet resistance of the Ga2O3 channel and thus limited their high-frequency device performance. These results suggest that both suppressing the short channel effect with a reduction in Lg to the sub-0.1-μm range and minimizing the access resistance are important to further improve RF device characteristics of Ga2O3 MOSFETs.
Strong accumulation of Si impurities has been observed at a Ga2O3 epilayer/substrate interface. The highly Si-doped region around the interface typically becomes a current conduction path, causing buffer leakage for lateral Ga2O3 field-effect transistors (FETs). To overcome the drawback, we performed Mg- or Fe-ion implantation doping into a Ga2O3 substrate prior to the subsequent molecular-beam epitaxy growth to compensate the accumulated Si donors at the interface. The Mg implantation doping showed a minimal effect on reduction in the interface leakage, irrespective of its concentration. On the other hand, the Fe doping with a high density of 2 × 1019 cm−3 provided a significant decrease in the leakage and decent FET characteristics.
19 February 2021 in Japanese Journal of Applied Physics
An (AlGa) 2 O 3 back barrier was employed for Ga 2 O 3 metal-oxide-semiconductor field-effect transistors (MOSFETs) with a Si-implanted n -Ga 2 O 3 channel layer. The insertion of the back barrier led to strong confinement of electrons in the channel layer, and a shallower pinch-off characteristic with shifting a threshold gate voltage by +8 V was attained for the MOSFET with the back barrier compared to the conventional one without it. The excellent gate controllability represented by a subthreshold slope of 129 mV/decade was also achieved for the back-barrier MOSFET; whereas it was 337 mV/decade for the non-back-barrier one.
1 February 2005 in Japanese Journal of Applied Physics
The air stable n-type carbon nanotube channel filed effect transistor (CNT-FET) with the top gate structure was successfully fabricated using the silicon nitride gate insulator deposited by the thermal chemical vapor deposition. The effects of the silicon nitride insulator on the electrical properties of the CNT-FET have been investigated. The p-type characteristics of the CNT-FET can be converted to the n-type characteristics in high yield of 90% only by depositing the silicon nitride insulator. The drain current is as high as few µA order. The n-type top gate CNT-FET stably operated even in ambient air.