Solar evaporation of seawater is promising to mitigate the fresh water scarcity problem in a green and sustainable way. However, salt accumulation on the photothermal material prevents the system continuous operation, and the water supply driven by capillary force severely limits the scale-up of the evaporators. Here, we demonstrate a double-sided suspending evaporator with top water supply and a surface water distributor for high-efficient concurrent solar evaporation and salt harvesting for large area applications. Both sides of the evaporator can evaporate water with automatic salt harvesting from the edge concurrently. Top water supply gets away from the limitation of capillary force for a larger area application and completely cuts off the heat leak to the bulk water below for higher efficiency. The energy conversion efficiency reaches 95.7% at 1.40 kg·m-2·h-1 with deionized water under 1 sun with a remarkable low surface average temperature (28.2 °C). Based on the simulation and experiment, a novel radial arterial water distribution system is developed to efficiently distribute water on a larger evaporation surface. The water distribution system alters the water transport path in the evaporation surface, leading to salt accumulation on the surface body, where salt is unable to be harvested by gravity automatically. This problem is further resolved by cutting out the salt accumulation area (16.4%) on the surface to create a floriform evaporator, which forcedly exposes the salt at the edge for harvesting. Up to70 h continuous solar evaporation from salt water at a rate of 1.04 kg·m-2·h-1 with concurrent salt collection on this floriform evaporator is achieved. This work resolves water supply and salt accumulation problems in scaling up the solar evaporators and advances the structural design of evaporators for high-efficient large area applications.
26 November 2018 in Industrial & Engineering Chemistry Research
One of the key challenges faced by hypersonic flying is the complex thermal–mechanical–chemical coupling effect between thermal protection materials and non-equilibrium flow environment. Silicon carbide (SiC) has drawn much attention due to its superior physical and chemical characteristics, and its performance under hyperthermal atomic oxygen (AO) impact, however, is still little known. This work investigates the effects of various SiC crystalline polytypes, surface temperature, and crystal orientations on the SiC interface evolution by hyperthermal AO collisions via the reactive molecular dynamics method. The results showed that SiC surface erosion is highly dependent on the temperature and the presence of different interfacial structures. In the range of 500–2000 K, the proceeding of the passive oxidation advances the amorphous SiO2/SiC interface and the formation of SixOy phase weakens the surface catalytic characteristics and mechanical properties. The presence of defects, such as dangling bonds at the gas–solid interface, caused by different surface orientations affects the anti-erosion capabilities of SiC significantly, which may limit its further wide applications.
The thermal protection system is essential for the safe and reliable flying of any high-speed aircraft. A carbon fiber-reinforced phenolic resin (PR) composite is one of the most important matrix candidates for ablative materials, and the microscopic understanding of the pyrolysis process of PR, however, still remains poor. The usual numerical approach is based on volumetric pyrolysis while neglecting the influence of external hyperthermal surroundings. A surface-volume coupled reactive molecular dynamics model is established in this work to simulate complicated heat/mechanics/chemistry multi-physical field coupled pyrolysis problems. The pyrolysis process of the carbon fiber-PR composite is investigated in the presence of vacuum and hyperthermal gas impacts and compared with the volumetric pyrolysis simulation only. The consideration of the surface–volume coupling reveals many unique features beyond the volumetric pyrolysis, which include the generation of different pyrolysis products and the dependence of the effective mass diffusivity of pyrolysis gases on impinging gases in the presence of the hyperthermal non-equilibrium environment. With the detailed revelation of the evolutions of PR solid phase and pyrolysis gaseous products, the work is of great help in improving the microscopic pyrolysis mechanisms, especially the “blowing gas effect,” a key phenomenon for improved understanding of the complicated hypersonic boundary layer flow.