The laser–produced plasma extreme ultraviolet (LPP–EUV) source is the sole light source currently available for commercial EUVL (extreme ultraviolet lithography) machines. The plasma parameters, such as the electron temperature and electron density, affect the conversion efficiency (CE) of extreme ultraviolet radiation and other critical parameters of LPP–EUV source directly. In this paper, the optical emission spectroscopy (OES) was employed to investigate the time–resolved plasma parameters generated by an Nd:YAG laser irradiation on a planar tin target. Assuming that the laser–produced tin plasma satisfies the local thermodynamic equilibrium (LTE) condition, the electron temperature and electron density of the plasma were calculated by the Saha–Boltzmann plot and Stark broadening methods. The experimental results revealed that during the early stage of plasma formation (delay time < 50 ns), there was a significant presence of continuum emission. Subsequently, the intensity of the continuum emission gradually decreased, while line spectra emerged and became predominant at a delay time of 300 ns. In addition, the evolution trend of plasma parameters, with the incident laser pulse energy set at 300 mJ, was characterized by a rapid initial decrease followed by a gradual decline as the delay time increased. Furthermore, with an increase in the incident laser pulse energy from 300 mJ to 750 mJ, the electron temperature and electron density of laser–produced tin plasma exhibiting a monotonically showed increasing trend at the same delay time.
Laser-spot-location detection technology based on photodetectors is widely used in the aerospace, medical, military and communication fields. However, most of the current research focuses on continuous laser detection in the visible and near-infrared bands, and the real-time high-precision position detection of a long-wave infrared pulsed laser is lacking. In this paper, a spot-position detection system based on a four-quadrant detector is designed for a 10.6 μm CO2-driven laser in extreme ultraviolet light source, and a second-order extended error compensation algorithm based on a Gaussian-spot model is proposed. Finally, the algorithm is verified and analyzed experimentally by a spot-position detection system under both focusing and defocusing conditions. The experimental results show that the root-mean-square error, maximum absolute error and average absolute error of the second-order error compensation algorithm are significantly reduced compared with the traditional algorithm, and the detection accuracy of the spot-position is better than 9 μm. The above results show that this spot-position detection system has obvious advantages and high accuracy, which can realize the high-precision real-time detection of a laser’s spot position to obtain accurate spot position information, provide feedback adjustments for subsequent beam pointing control, and provide a theoretical basis for the beam pointing stability of the extreme ultraviolet light source system.