Experience shows that dilution of lubricating oil with diesel oil is unfavorable to the engine, causing issues including deterioration of engine performance, shortening of oil life, and reduction in engine reliability and safety. This paper presents the verification of the hypothesis that the changes in lubricity, friction coefficient, and decreasing oil film thickness (using a relative approach, given as a percentage) are similar for lubricating oil and diesel mixtures prepared from fresh lubricating oil and used lubricating oil. To validate this hypothesis, an experiment is conducted using a high-frequency reciprocating rig (HFFR), in which the lubricity is determined by the corrected average wear scar WS_1.4, the coefficient of friction μ, and the percentage relative decrease in oil film thickness r. A qualitative visual assessment of the wear scars on the test specimens is also performed after the HFFR tests. The testing covers mixtures of SAE 30 grade Marinol CB-30 RG1230 lubricating oil with Orlen Efecta Diesel Biodiesel. The used lubricating oil is extracted from the circulating lubrication system of a supercharged, trunk-piston, four-stroke ZUT Zgoda Sulzer 5 BAH 22 engine installed in the laboratory of ship power plants of the Maritime University of Szczecin. Mixtures for the experiment are prepared for fresh lubricating oil with diesel oil and used lubricating oil with diesel oil. Mixtures of these lubricating oils with diesel oil are examined for diesel oil concentrations in the mixture equal to 1, 2, 5, 10, 15, and 20% m/m. The results of the experiment confirm the hypothesis, proving that, for up to 20% m/m diesel oil concentration in lubricating oil, the changes in the lubricity of used lubricating oil diluted with diesel oil can be evaluated based on reference data prepared for mixtures of diesel oil with fresh lubricating oil. The linear approximation of μ and r trends is made with a certain margin of error we estimated. The experiment also confirms the results of previous studies which state that oil aging products in small quantities contribute to improved lubricity.

This article presents the verification of the hypothesis on using certain approximation curves in the evaluation of used lubricating oil. These curves are plotted for fresh lubricating oil to approximate the parameters of lubricating oil diluted with diesel oil. To confirm the hypothesis, an experiment is conducted to determine the flash point, initial boiling point, density at 15 °C, kinematic viscosity at 40 °C and 100 °C, and viscosity index. The analysis covers fresh oil and used SAE 30 grade Marinol CB-30 RG1230 oil taken from the circulating lubrication system of a supercharged, trunk-piston, 4-stroke ZUT Zgoda Sulzer 5 BAH 22 engine that is located in the Marine Power Plant Laboratory of the Maritime University of Szczecin. Undiluted lubricating oils (both fresh and used) and mixtures of lubricating oils with diesel oil are examined for diesel oil concentrations in the mixture equal to 1, 2, 5, 10, 15, and 20% m/m. Orlen Efecta Diesel Biodiesel is used to prepare the mixtures. The functions approximating the parameters for fresh oil are determined and adapted to describe the variation of the same parameters for the used lubricating oil. For each case, the coefficient of determination, the maximum relative error of the model fitting to the experimental results, and the root mean square error (RMSE) are determined. In the experiment, the variation in the parameters of the used lubricating oil remained the same as for fresh oil parameters. Thus, the research hypothesis is confirmed.