Basements are increasingly being used as living and working spaces, and the interest in the feasibility of using wireless devices in these environments is increasing. Therefore, it is very important to develop a propagation prediction model for basements. Especially, the isolated communication cell against the satellite or the other building will be promising due to the lack of available frequency resources. However, the propagation model for outdoor-to-basement has not been reported. Only the outdoor-to-indoor in the overground environment has been studied. Therefore, as far as our knowledge, this letter could be the first approach for the building entry loss (BEL) to analyze propagation paths to a basement from outside the building. Experiments were conducted on the basis of three different scenarios for the propagation paths between the exterior of the building and the basement. The BEL was measured at 61 and 71 dB at frequencies of 1.5 and 3 GHz, respectively; these values exceeded the value of about 30 dB of the over-the-ground model described in the International Telecommunications Union Radio-communication Sector P.2109. Further, BEL on the ground floor of the building and the penetration loss between the different floors were measured. Finally, BEL on the building side with parking lot entrance was evaluated.
30 November 2021 in The Journal of Korean Institute of Electromagnetic Engineering and Science
Wireless communication technologies are expected to become essential in future self-driving vehicles. This study presents an antenna for vehicle wireless communication with a bandwidth of 75 MHz at a Wireless Access in Vehicular Environment frequency of 5.885 GHz. To compensate for the backward link path loss from the vehicle interior and passengers, the antenna is designed to have asymmetric gains of 0 and 6 dBi at 0° and 180°, respectively. The antenna is validated through an outdoor road test. We measured the received continuous-wave (CW) power, received signal strength indicator, and packet-delivered ratio (PDR) of the digital signal under vehicle-to-vehicle communication mode. Similar power is received in both the backward and forward scenarios. The forward and backward PDR are also similar.
In this paper, a volumetric Rotman lens antenna operating at 28 GHz is proposed. The design formula and procedure were derived for the 3-D Rotman lens antenna. The number of tilted beams is 3 × 3. The six rectangular blocks are assembled using a metallic bolt. The input port consists of a waveguide, and the output port is made of an open-ended waveguide. The input and output waveguides are drilled in a flat conducting plate. The input and output port positions are optimized. Simulated and measured results show that the radiating beam is controlled almost exactly as calculated. Compared with the previous two-stage stacked Rotman lens antenna, the proposed Rotman lens antenna can dramatically decrease the antenna volume by approximately 75%.
31 July 2023 in The Journal of Korean Institute of Electromagnetic Engineering and Science