Soon-Soo Oh

Prof. Dr. Soon-Soo Oh


Research Focus & Metrics

Academic Career Length

23Years (2004-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
29 September 2021 in IEEE Access
Verified
Journal Article
Open access
Young Chul LeeYoung Chul Lee
Young Chul Lee
SOSoon-Soo Oh
Soon-Soo Oh
CBChul Woo Byeon
Chul Woo Byeon
KAKhairunnisa Aziding
Khairunnisa Aziding
BCByung-Lok Cho
Byung-Lok Cho
We investigated the impact of window penetration loss (WinPL) on the frequency dependence of building entry loss (BEL) from 3.5 to 24 GHz. The WinPL characteristics of an ideal double-glazed glass and an actual double-glazed window were simulated and measured on-site, respectively, and both results showed almost the same oscillatory characteristics with respect to the frequency changes that occurred due to the impedance oscillation of the double glass-like multilayer dielectrics. Two BEL measurement scenarios were examined to analyze the frequency dependence of BEL in a traditional office building with double-glazed windows identical to those analyzed in the on-site WinPL measurements. The experiments included a complex propagation route (the first scenario) from the facade of the building to the corridors through windows and offices and a simple propagation route (the second scenario) through only windows lateral to the building. The two main findings are (i) BEL showed strong frequency-dependent behavior regardless of the propagation route and (ii) the WinPL characteristics of the outer double-glazed window were the main contributors to the frequency dependence of BEL.

30 September 2008 in IEEE Transactions on Antennas and Propagation
Verified
Journal Article
Closed access
SOSoon-Soo Oh
Soon-Soo Oh
LSLotfollah Shafai
Lotfollah Shafai
The polarization characteristic of unloaded and loaded square-ring microstrip antennas is investigated. Several different loading types like single-stub, dual-stub, notch, gap and shorting-pin are considered and their effects are studied. Loading enables feeding using a 50-Omega probe. The simulation and measurement results show that the loading techniques excite a loaded TMy 11 mode that is orthogonal to the unloaded TMx 11 mode. This indicates that by loading the ring antenna its polarization can be switched adaptively. However, the purity of the loaded and unloaded modes depends on the loading type. For some loading types like gap and shorting-pin, the excitation of the unloaded mode seems negligible, in comparison to the loadings by stub and notch. For the stub and notch loaded antennas the unloaded mode is also present, and its excitation efficiency is frequency dependent. Thus, their polarization plane, which is due to both loaded TMy 11 and unloaded TMx 11 modes, also becomes frequency dependant. The results of this investigation can be useful in selecting the loading methods for high-impedance microstrip ring antennas, and control of their impedance and polarization. The knowledge of the antenna polarization is essential in communications, and its dependence on the loading type can be used as an important parameter in design of adaptive antennas and sensors.

26 April 2018 in International Journal of Antennas and Propagation
Verified
Journal Article
Open access
PDF file
SOSoon-Soo Oh
Soon-Soo Oh
DKDong-Woo Kim
Dong-Woo Kim
SNSe-Woong Na
Se-Woong Na
JKJin-Dae Kim
Jin-Dae Kim
WPWook-Ki Park
Wook-Ki Park
Communication between moving vehicles is very important for safety. In this paper, a bidirectional antenna that can be installed inside a vehicle is proposed and tested in a real vehicular environment at 5.8 GHz. The forward link and backward link seated by two persons and three persons were compared in terms of received RF power and the peak-to-average power ratio (PAR). It was found that, even with three persons, the power link fulfilled the communication requirements using the proposed antenna.

21 February 2019 in Microwave and Optical Technology Letters
Verified
Journal Article
Closed access
PDF file
SOSoon-Soo Oh
Soon-Soo Oh
JCJae‐Won Choi
Jae‐Won Choi
HLHwa‐Choon Lee
Hwa‐Choon Lee
YLYoung‐Chul Lee
Young‐Chul Lee
BCByung‐Lok Cho
Byung‐Lok Cho
SPSung Won Park
Sung Won Park

31 January 2021 in Journal of Electromagnetic Engineering and Science
Verified
Journal Article
Open access
PDF file
SOSoon-Soo Oh
Soon-Soo Oh
JCJae-Won Choi
Jae-Won Choi
DKDong-Woo Kim
Dong-Woo Kim
YLYoung-Chul Lee
Young-Chul Lee
BCByung-Lok Cho
Byung-Lok Cho

4 December 2013 in ETRI Journal
Verified
Journal Article
Open access
PDF file
SOSoon-Soo Oh
Soon-Soo Oh
YLYoung Hwan Lee
Young Hwan Lee
We propose a way to measure the absorber reflectivity at a low cost. Only one simple antenna with a small radiating aperture and a frequency‐domain instrument are utilized. The previously used equation for calculating the reflectivity of an absorber is inaccurate, and, therefore, a new equation is derived based on multiple reflection analysis and three test models. Notably, the reflection coefficient of the antenna is included in the derived equation. The accuracy of the proposed method is proven through simulation and measurements. It can be easily applied to a product examination by absorber manufacturers and customers owing to its advantages of simplicity, cost effectiveness, and non‐cutting examination.