Gas injection for enhanced oil and gas reservoir recovery is a crucial method in offshore Carbon Capture, Utilization, and Storage (CCUS). The B6 buried hill condensate gas reservoir, characterized by high CO₂ content, a deficit in natural energy, developed fractures and low-pressure differentials between formation and saturation pressures, requires supplementary formation energy to mitigate retrograde condensation near the wellbore area through gas injection. However, due to the connected fractures, the B6 gas reservoir exhibits strong horizontal and vertical heterogeneity, resulting in severe gas channeling and a futile cycle, which affects the gas injection efficiency at various levels of fracture development. Based on these findings, we conducted gas injection experiments and numerical simulations on fractured cores. A characterization method for oil and gas relative permeability considering dissolution was established. Additionally, the gas injection development boundary for this type of condensate gas reservoir was quantified according to the degree of fracture development, and the gas injection mode of the B6 reservoir was optimized. Research indicates that the presence of fractures leads to the formation of a dominant gas channel; the greater the permeability difference, the poorer the gas injection effect. The permeability gradation (fracture permeability divided by matrix permeability) in the gas injection area should be no higher than 15; gas injection in wells A1 and A2 is likely to achieve a better development effect under the existing well pattern. Moreover, early gas injection timing and pulse gas injection prove beneficial in enhancing the recovery rate of condensate oil. The study offers significant guidance for the development of similar gas reservoirs and for reservoirs with weakly connected fractures; advancing the timing of gas injection can mitigate the retrograde condensation phenomenon, whereas initiating gas injection after depletion may reduce the impact of gas channeling for reservoirs with strongly connected fractures.

The B6 metamorphic buried hill condensate gas reservoir exhibits a highly compact matrix, leading to a rapid decline in bottom-hole pressure during initial production. The minimal difference between formation and saturation pressures results in severe retrograde condensation, with multiphase flow further increasing resistance. Conventional numerical simulations often overestimate reservoir energy supply due to their failure to account for this additional resistance, leading to inaccuracies in bottom-hole pressure predictions and gas–oil ratio during history matching. To address these challenges, this study conducted research on nonlinear numerical simulation for buried hill condensate gas reservoirs and established a method for calculating a multiphase pressure sweep range based on the well testing theory. By correcting and fitting the pressure propagation boundaries with numerical simulation, the nonlinear flow parameters applicable to the B6 gas field were inversed. This study revealed that conventional Darcy flow is inadequate for predicting pressure propagation boundaries and that it is possible to reasonably characterize the pressure sweep range through nonlinear flow. This approach resulted in an improvement in the accuracy of historical matching for bottom-hole pressure and gas–oil ratio, which improve the historical fitting accuracy to 85%, providing valuable insights for the development of similar reservoirs.