In the production of geometries that traditional methods cannot produce, it is seen that additive manufacturing (AM) technology, which has come to the fore, has been used extensively in conformal cooling channel (CCC) applications in recent years. This study, conducted within the scope of CCC's use of applied mold cores in automotive industry plastic part production, aimed to reduce the cycle time in the injection printing process. The v1 geometry, which gives the analysis results for ideal printing quality from the channel geometries developed with three different design approaches, is produced with direct metal laser sintering, which is an AM laser sintering technology, and the injection printing cycle time has been reduced by 38%. CCC applied the study's primary motivation to develop duct geometry to provide balanced cooling in the automotive industry's mold cores produced with AM. It is known that the Computer Numerical Control machining process in traditional mold methods does not allow the processing of the channels in the internal geometries, and the deep areas where the heat is concentrated cannot be cooled sufficiently. In the study, CCC geometries where AM design parameters are used effectively and the balanced cooling performance expected from the die core can be achieved. The effects of different geometries on production are discussed.
18 April 2023 in The International Journal of Advanced Manufacturing Technology
Aluminum-based cellular structures are gaining a huge traction in several applications, including lightweight aircraft, military equipment, and heat exchangers. With additive manufacturing, the fabrication of complex periodic cellular structures with any unit cell form, size, and volume fraction has become a lot easier, allowing for more investment, research, and attention from both academia and industry. The aim of the research was to assess the manufacturability and performance of AlSi10Mg periodic cellular structures generated using the laser powder bed fusion process. Re-entrant and triply periodic and minimum surface (TPMS) gyroid cells were hybridized into a single cellular structure having identical volume fraction. Because of distinct mechanical properties of TPMS and re-entrant types, these cells were selected and assembled in various patterns to study their manufacturability, deformation behavior, energy absorption, and compressive strength. This work demonstrates good geometric agreement between the manufactured hybrid lattice structures and computer-aided design models. Hybridized structures with several repeated layers of TPMS gyroid and re-entrant cells can result in superior compressive strength and energy absorption than those with only few large layers.
29 September 2022 in Journal of Manufacturing Processes