In this paper, the robust stability and tracking control of Micro-hand system are researched, wherein the influence of hysteresis characteristics is eliminated, and the tracking accuracy is improved. Firstly, the generalized hysteresis operator is combined with isomorphism to factorize the system, and then controllers are designed to stabilize the hysteretic Micro-hand system. Secondly, a parallel compensation operator is discussed by combining the right coprime factorization, which eliminates the influence of hysteresis. Thirdly, a terminal sliding mode $-$ parallel compensation $-$ robust right coprime factorization tracking control scheme is proposed, which further reduces the error and improves the tracking accuracy. Finally, the effectiveness of the proposed scheme is verified by simulation results.
In a nonlinear control system, hysteresis exists usually as common characteristics. In addition, external output disturbances like modelling error, machine friction and so on also occur frequently. Both of them are considered to cause instability and unsatisfactory performance. In this paper, a practical nonlinear control system design is proposed so as to achieve the simultaneous control of input hysteresis and output disturbance. The system is based on RCF (right coprime factorization theory). Additionally, the proposed design has been applied to a soft robotic finger system and the results of simulations and practical experiments are exhibited, which show the effectiveness of the proposed system.
Real-world plants have various nonlinear characteristics such as friction and hysteresis, so nonlinear control is essential for precise control. In addition, actuators of plants have input constraints, which cause the integrator of the controller to windup. So far, anti-windup methods have mainly been for linear controllers, and research on nonlinear controllers has not been sufficient. This paper proposes a back-calculation anti-windup method for nonlinear controllers. By analyzing and extending the back-calculation anti-windup for a Proportional–Integral controller using operator theory, it can be applied to nonlinear controllers. The proposed method is applied to integral sliding mode control and right coprime factorization. In the simulation, we compared the proposed method with and without its application, as well as with conditional integration, and confirmed the effectiveness of the proposed method. In the future, it is necessary to extend the method to be applicable to more complex systems. This study has the potential to contribute to the practical application of nonlinear control.
Soft robots are attracting attention as next-generation robots because they enable flexible movement. The micro finger is a soft robot that can bend and is small and can grasp objects of various shapes, so it is expected to be applied to surgical robots. However, because it is small, sensors cannot be attached, making it difficult to measure force. This paper proposes impedance control of the tip of a micro finger by estimating the tip force with an observer. The control system is designed using coprime factorization and Youla–Kucera parameterization by operator theory. The effectiveness of the proposed method is confirmed through experiments.