In this work, micro air vehicles (MAVs) equipped with bio-inspired wings are investigated experimentally in wind tunnel. The starting point is that insects such as dragonflies, butterflies and locusts have wings with rigid tubular elements (corrugation) connected by flexible parts (profiling). So far, it is important to understand the specific aerodynamic effects of corrugation and profiling as applied to conventional wings for the optimization of low-Reynolds-number aerodynamics. The present study, in comparison to previous investigations on the topic, considers whole MAVs rather than isolated wings. A planform with a low aperture-to-chord ratio is employed in order to investigate the interaction between large tip vortices and the flow over the wing surface at large angles of incidence. Comparisons are made by measuring global aerodynamic loads using force balance, specifically drag and lift, and detailed local velocity fields over wing surfaces, by means of particle image velocimetry (PIV). This type of combined global–local investigation allows describing and relating overall MAV performance to detailed high-resolution flow fields. The results indicate that the combination of wing corrugation and profiling gives effective enhancements in performance, around 50%, in comparison to the classical flat-plate configuration. These results are particularly relevant in the framework of low-aspect-ratio MAVs, undergoing beneficial interactions between tip vortices and large-scale separation.
The behavior of dispersed particles in a turbulent round jet is experimentally investigated. The role of particle-to-fluid density ratio is analyzed by inspecting particle velocity fields and preferential concentration at four different ratios, from 0.7 to 19.3. The jet near-field region, i.e., up to , is analyzed and compared to the unladen case. Particle-to-fluid density ratio is reported to have a strong impact on particle velocity field structure, in terms of jet transition and self-similar region as well as on turbulent fluctuations. Concentrations of particles show that increasing particle density corresponds to larger departure from uniformity. This occurrence is limited to the region , where also the largest differences of average and fluctuating velocities with respect to the unladen case are measured.
1 August 2021 in 14th International Symposium on Particle Image Velocimetry
Plunging jets are used in many industrial and civil applications, as for example in sewage and water treatment plants, in order to enhance aeration and mass transfer of volatile gases. They are also observed in natural processes as rivers self-purification, waterfalls and weirs. Many investigations dealt with the plunging jets in different configurations, but the dependence on Reynolds number and jet geometry were still not sufficiently addressed. For example, Mishra et al. (2020) studied an oblique submerged water impinging jet at different nozzle-to-plate distances and impingement angles, but only at a rather small Reynolds numbers (2600). On the other hand, different jet geometries have been extensively considered, but not for the plunging jet configuration (Mi, 2000; Hashiehbaf &Romano, 2013). In this work, plunging water jets issuing in air from orifices of different shape are considered. The aim of the work is to detail and compare jet behaviors in terms of velocity fields generated after impacting the air-water interface, as a function of Reynolds number and orifice geometry. However, air bubbles entrainment is mainly avoided in order to study the jet characteristics in a simpler case and use it as a reference starting point for future works.