Organic phase change materials (PCMs) have been utilized as latent heat energy storage medium for effective thermal management. In this work, a PCM nanocomposite, consisting of a mixture of two organic PCMs (referred to as eutectic gel PCM) and minimal amount (0.5 wt%) of nanographite (NG) as a supporting material, was prepared. Differential scanning calorimeter was used to determine the melting temperature and latent heat of pristine PCM, paraffin (61.5 °C and 161.5 J/g), eutectic gel PCM (54 °C and 158 J/g) and eutectic gel PCM nanocomposite (53.5 °C and 155 J/g). The prepared PCM nanocomposites exhibited enhanced thermal conductivity and ultrafast thermal charging characteristics. The nanocomposites were employed for two different applications: (i) providing hot water using an indigenously fabricated solar water heating (SWH) system and (ii) solar rechargeable glove that can be rapidly warmed and used. Experimental results on SWH system show that the use of PCM nanocomposites helps to increase the charging rate of PCM while reducing the discharging rate of heat by PCM to water, thus enhancing the maximum utilization of solar energy and hence improving the efficiency of the SWH system. The experimental results on solar rechargeable glove revealed that the glove has the ability to retain the temperature up to 3 hours
Printing of electronic devices on a paper substrate using 2D graphene-based ink is an opening gate to innovative applications, where devices would be biodegradable, eco-friendly and can be disposed of with negligible impact on the environment. A resistor is a key element of electronic devices and their application area depends upon its power rating and temperature coefficient of resistance (TCR). In this work, in house developed graphene ink is successfully utilized to fabricate a paper-based resistor using a bar coating technique. Dimensional patterning with precise known values of resistance is achieved using a laser with freedom of shape and size which has been explored for the first time on a paper substrate. The resistor has potential to handle ∼7 W power at room temperature with capacity to withstand up to 200 V which is the highest among reported printed resistors. A dual, low and high TCR is observed, correspondingly in cold (173 K to 300 K) and hot (300 K to 373 K) temperature regions with an activation energy Ea of ∼8 meV for the cold region which is 375 percent lower than the hot region (∼30 meV). The dual TCR behaviour is of great importance for application as a stable resistor up to room temperature, and as a thermistor above room temperature.
22 September 2014 in ACS Applied Materials & Interfaces